Ferrini venue Use And Instruction Book

Summary of venue

  • Page 1

    Libretto d’istruzioni e garanzia use and instruction book libretto-ferrini_layout 1 25/10/10 18:49 pagina 1.

  • Page 2

    Libretto-ferrini_layout 1 25/10/10 18:49 pagina 2.

  • Page 3: Use And Instructions Book

    Use and instructions book english introduction chapter 1 use adjustments chapter 2 safety chapter 3 checks and adjustments chapter 4 maintenance chapter 5 warranty 38 39 42 44 57 59 pag. Pag. Pag. Pag. Pag. Pag. Libretto-ferrini_layout 1 25/10/10 18:50 pagina 41.

  • Page 4: Use And Instructions Book

    42 use and instructions book introduction dear customer, the bicycle you chose is absolutely reli-able and safe. It is the result of specialized technical researches and qua- lity controls that guarantee reliability and give you the pos- sibility to appreciate safely its performances. The owners man...

  • Page 5: Chapter 1

    English 43 chapter 1 use adjustment before using the first time the bicycle has to be checked and adjusted according to the characteristics of the owner verifying also his reactions. The bicycle 1 frame • 2 top tube • 3 down tube 4 seat post • 5 rear chainstays • 6 rear seat stays • 7 head tube • 8 ...

  • Page 6: Use And Instructions Book

    44 use and instructions book saddle position when riding the big toes have to lean on the centre of the pedal. When the pedal is nearest to the ground your knee has to be lightly bended. Straddle the saddle, lean your heel on the pedal and move nearest to the ground. In this way your leg will be com...

  • Page 7: Warning/important:

    English 45 stem in the right position (with 20 nm). If you have a ahead set han- dlebar the height cannot be adjusted. In this case you have to operate on the two screws that lock the handlebar (stee- ring) a1 and a2 (fig. 5). You can set the steering flowability by adjusting the b screw. Finally lo...

  • Page 8: Use And Instructions Book

    46 use and instructions book chapter 2 riding your bike in safety for a safe use of your bike it is necessary and very impor- tant: - to know the bicycle traffic rules of your country and of the countries where you will ride your bike. - to ride the bicycle following the normal traffic direction, in...

  • Page 9: Warning/important:

    - braking well in advance gradually to avoid falling and losing your bicycle control, consider that going down-hill there is a decreased grip of the tyres. - replacing immediately any bicycle components that are damaged. - making sure that your bicycle is in good overall conditions and providing for...

  • Page 10: Use And Instructions Book

    48 use and instructions book chapter 3 checks and adjustments every time before using your bicycle you have to check it carefully and if you have any doubt or problem please con- tact immediately your dealer. Wheels to make sure that the wheels are centered you have to check if the rim of each wheel...

  • Page 11: Warning/important:

    Warning/important: check the fixture or the position of the tyres particularly after long downhill routes. Using your bike with the recom- mended air pressure in the tyres ensures prolonged safety and lifetime. Braking system the brakes have to be checked when the bicycle is still. Pull the levers o...

  • Page 12: Use And Instructions Book

    50 use and instructions book before riding check the stand position that has to be completed raised. Brake system adjustment our bicycles are equipped with four different brake systems: - disc brake (fig. 9) - caliper brake (fig. 10) - v-brake (fig. 11) - coaster brake when adjusting the caliper or ...

  • Page 13: Warning/important:

    Brake pads has to be adjusted 0,2-0,4 mm working on the relevant screws. The hydraulic brakes are adjusted automatically. Warning/important: for the best performance the brake pads have to reach the minimum wear. Do not touch the discs when you stop as they overheat when working. It is fundamental t...

  • Page 14: Use And Instructions Book

    52 use and instructions book you will find the perfect rhythm by a ratio of 60 and 90 pedal rpm (revolutions per minute). The front and rear derailleur that allow you to change the speed moving the chain from a gear to another is the most used one. There are other types of shifts and each one is rig...

  • Page 15: Warning

    Warning /important: we suggest to avoid always the following combinations as the chain would be out of line and could encounter friction: small front gear with rear small one or big front gear with big rear one (fig. 16). In any moment you can find and adapt the speed according to your requirements....

  • Page 16: Use And Instructions Book

    54 use and instructions book front and rear derailleur adjustment to adjust the front and rear derailleur, you have to keep your bicycle raised from the ground in order to allow to drive the gears and the shift system keeping the bicycle still. If the gear change operation is not perfect, adjust the...

  • Page 17: Warning/important:

    The screws are originally adjusted by the producer and cannot be modified during the normal use, so the comple- te front and rear derailleur adjustment has to be done by the dealer. Warning/important: for the adjustment and maintenance of the shifts you have to contact exclusively your dealer as thi...

  • Page 18: Use And Instructions Book

    56 use and instructions book never use high pressure water jets when washing your bicycle, if the water penetrates into the bearings they could be damaged and loose their qualities. The suspended forks have to be lubricated periodically in order to guarantee a good performance and a long lasting lif...

  • Page 19

    The quick release has to be correctly adjusted and fasten- ed as described here below. To take the wheel out, you have to open the quick release of the side pull brakes or remove the cantilver of v- brake arc; pull the hubs relea- se lever until you reach posi- tion open (fig. 21) and loosen the fix...

  • Page 20: Use And Instructions Book

    58 use and instructions book to the following tightening: front 40 nm and rear 40 nm. Then check again. Particularly verify if the nuts fixing the wheels to the threaded hub axle is well fastened or if the quick release lever that allows to put the wheel in and off without using any equip- ment is w...

  • Page 21: Warning/important:

    Around the rim. If the track is not evident, it means that the braking surface is worn and it is necessary to replace the rim. After making all these checks , if you note any anomalies or if you have any doubt about the status of the wheels, con- tact your dealer to get assistance. Warning/important...

  • Page 22: Use And Instructions Book

    60 use and instructions book all the screws have to be well tightened, if one plate only is loosen, it is almost impossible to get down from your bicycle. Into the producer manual you will find all the instructions for the pedals adjustment. Warning/important: always check if the pedals are well and...

  • Page 23: Chapter 4

    Chapter 4 maintenance and lubrication we suggest a periodical maintenance of your bicycle to get always the best performances and guarantee your safety. Book right now your first check by the dealer. After two months from the purchase date or anyway after riding 200-400 km it is necessary to do a fi...

  • Page 24: Use And Instructions Book

    62 use and instructions book bolts and nuts fastening in the maintenance program we suggest you to check periodically if the screws that are subject to loosen are well fastened or not. This check has to be done using a dyna- mometric key that automatically takes off when the optimal fastening couple...

  • Page 25: Chapter 5

    English 63 c omponents nut/wing front hub tightening nm 40-45 nut/wing back hub nm 40-45 saddle clamp nut nm 20-24 brake fixing bolt nm 7-10 brake shoe fixing bolt nm 5-8 saddle post tube bolt nm 10-14 handlebar expander bolt nm 18-20 rear derailleur bolt nm 8-15 front derailleur bolt nm 5-7 stem bo...

  • Page 26: Use And Instructions Book

    64 use and instructions book the purchaser right of cancel the contract, ask for damages refund or for a price reduction are out of the question. Manpower, transport and other costs originating from defects are not covered by the warranty. To enjoy the use of the warranty you have to contact exclu- ...

  • Page 27: Compliances

    Compliances to guarantee the quality of this bicycle, the design and the manufacturing are done in compliance with the most upda- ted en 14764, en 14765, en 14766, en 14781 european norms. Lifetime the disposal of the components that have finished their lifetime has to be done by the authorized wast...

  • Page 28: Use And Instructions Book

    Warranty use and instructions book 66 libretto-ferrini_layout 1 25/10/10 18:50 pagina 66.

  • Page 29

    English 67 warranty conditions 1) maxtec ltd guarantees bicycles having the ferrini trade brand. It gau- rantees all its components and parts from flaws and defects coming from construction and assembly, moreover it guarantees the high quality of the materials used. 2) this guarantee is valid for a ...

  • Page 30: Use And Instructions Book

    Use and instructions book 68 corroding substances cause an early deterioration of the warnish, especial- ly around the bottleholder and slide area; the flaws and defects of this sort will be considered due to negligence and therefore they are not covered by this warranty. 6) maxtec ltd is empowered ...

  • Page 31

    English 69 p u rc h a s e d m o d e l f ra m e n u m b e r n a m e a g e d a te o f p u rc h a s e a d d re s s z ip c o d e c it y 1 - h a v e y o u e v e r b o u g h t, b e fo re t h is o n e , o th e r f e rr in i p ro d u c ts ? O y e s o n o 2 - w h ic h c h a ra c te ri s ti c s m a d e y o u ...

  • Page 32: Use And Instructions Book

    Use and instructions book 70 s ta m p 1 , g o lia m o k o n a rs k o s h o s s e s tr . - 4 0 2 7 p lo v d iv b u lg a ri a te l. + + 3 5 9 3 2 9 2 1 9 0 9 - f a x + + 3 5 9 3 2 9 2 1 9 2 1 in fo @ m a x te c b ik e .E u - w w w .M a x te c b ik e .E u libretto-ferrini_layout 1 25/10/10 18:50 pagina...

  • Page 33

    English 71 for the retailer ferrini warranty libretto-ferrini_layout 1 25/10/10 18:50 pagina 71.

  • Page 34: Use And Instructions Book

    Use and instructions book 72 for the customer to keep purchased model frame number date of sale customer name age address zip code city country telephone e-mail furthermore i will give my consensus on the treatment and/or communication of all the data relative to the execution of all the operations....

  • Page 35

    English 73 model year size frame date of purchase date of review: retailer stamp: annual service to be done • check of shock mounts incl. Lubricating the bushings • check of swingarm pivot incl. Axle and mounts • check of hubs, bottom bracket and headset • check of all screws of the bike • check of ...

  • Page 36: Use And Instructions Book

    Use and instructions book 74 mode year size frame date date o model year size frame date of purchase date of review: retailer stamp: annual service to be done • check of shock mounts incl. Lubricating the bushings • check of swingarm pivot incl. Axle and mounts • check of rear shock according to the...

  • Page 37

    English 75 model year size frame date of purchase date of review: retailer stamp: annual service to be done • check of shock mounts incl. Lubricating the bushings • check of swingarm pivot incl. Axle and mounts • check of rear shock according to the enclosed shock manual • check of hubs • check of a...

  • Page 38: Use And Instructions Book

    Use and instructions book 76 mode year size frame date model year size frame date of purchase annual service to be done • check of shock mounts incl. Lubricating the bushings • check of swingarm pivot incl. Axle and mounts • check of rear shock according to the enclosed shock manual • check of hubs ...

  • Page 39

    English 77 model year size frame date of purchase annual service to be done • check of shock mounts incl. Lubricating the bushings • check of swingarm pivot incl. Axle and mounts • check of rear shock according to the enclosed shock manual • check of hubs • check of all screws of the bike • check of...

  • Page 40

    Notes libretto-ferrini_layout 1 25/10/10 18:50 pagina 78.

  • Page 41

    Notes libretto-ferrini_layout 1 25/10/10 18:50 pagina 79.

  • Page 42

    W w w . F e r r i n i - b i k e s . C o m 1, goliamokonarsko shosse str. - 4027 plovdiv bulgaria tel. ++359 32 921 909 - fax ++359 32 921 921 info@maxtecbike.Eu - www.Maxtecbike.Eu a part of the group libretto-ferrini_layout 1 25/10/10 18:50 pagina 80