Ferris 1846197 Installation Instructions

Installation

Instructions

Derby Stallion Oil Cooler Kit

Part No. 1846197

Kit Contents:

Ref Part No. Qty. Description

1

22467

2

Oil Cooler

2

1846152

1

Mount Bracket-Left

3

1846153

1

Mount Bracket-Right

4

1846154

1

Oil Cooler Mount

5

22106

2

3/8” Hose Fitting

6

21164

4

Hose Clamp

7

25299

8

Bolt, 1/4-20 x 3/4” Torx Head

8

25095

8

Nut, 1/4-20 Nylon Lock

9

50860-19 1

3/8” Hose, 19” (not shown)

10

50860-25 1

3/8” Hose, 25” (not shown)

11

50860-48 2

3/8” Hose, 48” (not shown)

12

50862-18 1

3/4” Wire Loom, 18” (not shown)

12

50862-24 1

3/4” Wire Loom, 24” (not shown)

13

21029

3

Long Tie Wrap (not shown)

14

21030

1

Short Tie Wrap (not shown)

This kit is for installing oil coolers to the

hydraulic system. This kit should be installed

when using the Triple Bagger Grass

Collection System.

WARNING

Before beginning any service work turn off the

PTO, set the parking brake, turn off the ignition,

and disconnect the spark plug wire(s).

1

© Copyright 2000 Ferris Industries. All Rights Reserved.

REMOVAL & INSTALLATION

1. Park machine on a flat, level surface and engage the

parking brake.

2. Remove and discard the fuel tank tie bar and the left

and right mounting brackets. SAVE the mounting

hardware.

3. Remove the split collars from the control cross shaft

and carefully lift the shaft assembly from the saddles.

Set the shaft on the ledge of the rear seat support to

allow for increased access room.

4. Subassemble the 19” and 25” hose lengths with one

of the barbed fittings on each hose and the appropri-

ate length of wire loom. Be sure the barbs are fully

inserted into the hose end. Applying a few drops of

oil on the barbs will make the assemble easier.

Figure 1. Kit Contents

NOTE: Some oil loss will occur when disconnecting the

hydraulic hoses. Remove and reconnect as quickly as

possible and prepare to contain the lost oil.

5. Remove the right return hose and loosen the jam nut

on the fitting on the pump. Rotate the fitting towards

the rear of the machine and point it slightly upwards

(see Figure 2). Tighten the jam nut.

6. Install the 19” hose assembly to the fitting on the

pump and tighten. Leave the free end of the hose

higher than the reservoir to prevent to hydraulic sys-

tem from draining.

Figure 2. Fitting Orientation

1

4

3

2

8

7

6

5

For all Derby Stallion ZT2354 mowers

1846261

Rev. 9/2000

TP 200-7030-00-SL-D