Ferroli GN4 N Operating, Installation And Maintenance Instructions - Gn4 N
5
English
Deutsch
Italiano
Français
Español
Português
Nederlands
Dansk
Türkçe
GN4 N
D Connect the panels together, using the screws 1, the washers 2 and the nuts 3,
reinforcing the bottom parts using the blades 4 fastened with the screws 5.
E
Loosen the nuts “A”. Insert the side fastening bracket “B”
F
Fasten the sides to the rear wall “A” using the screws “B”.
G Fit the side to the bracket “A” and fasten it using the screws “B” (right
side view). Repeat the operations in point G for the left side.
H Fasten the sides to the rear wall “A” using the screws “B”.
I
Fit the wiring protection case “A” using the screws “B” on the sides.
L
Fit the control panel to the sides using the tabs “A”. Place
the reinforcement spring “B” between the head of the screw
and the tab.
O Fit the upper panel “A”.
P
Fit the top cover or covers “A”, according to the length of the boiler (see table 1, sequence
C).
E
F
B
A
B
A
B
B
G
H
I
A
B
B
A
B
B
B
A
L
M
N
B
A
A
P
A
O
A
M Insert the 3 bulbs (safety thermostat, boiler thermostat and
thermometer).
N Fit the lower front panel “A”.