Fervi 419 Original Instructions Manual - Emergency
HARDWARE
Page 10 of 13
The Sander is equipped with a knob for adjusting the rotation
speed of the disc according to the type of material and the type
of work to be performed: the harder the material, the greater
the speed of rotation.
Turn the speed adjustment lever of the disc to the desired
position:
Figure 3 – Speed
adjustment lever.
To start the sander, that is activate the rotation of the tool, press down with the palm of your
hand
The sander's start lever is a continuous hold lever, in the sense that the function controlled
(i.e., the rotation of the disc) is active as long as the lever itself continues to be pressed.
Therefore, release the lever to shut it down in an emergency.
Emergency
In case of an emergency, immediately release the sander's power lever.
Disconnect the air hose and turn off the tool in the event of the following:
to replace the discs;
to clean, rebuild or perform maintenance on the sander;
if the sander is not used for some time.
fervi.com