Festivo 75 CF Instructions For Installation And Use Manual - page 7
7
FITTING THE COOLING CABINET
SHELVES
The cooling cabinet part has glass shelves
3 pcs and one half glass shelf as standard
equipment.
Fitting the shelves: see the picture.
ADJUSTMENT OF THE DOOR
If it is necessary to adjust the door, the
hinges can be adjusted to some degree
by loosing the fixing screws and moving
them in the directions of the arrows. Dra-
wing 1.
If the the door is not exactly vertical, loo-
sen the screws of the upper hinge. Turn
the hinge in a sideways direction (arrow)
until the door is vertical, and tighten the
screws.
Dimension A (drawing 2) must be same
both up and down. If it is not, move the
upper hinge in B arrows direction.
Check also the seal of the door.
If the seal is too compressed on the hinge
side, then move the hinge outwards. If the
seal has become pressed down, warm it
CAREFULLY with a hot-air blower (hair
dryer) and mould it with the fingers to
make it higher.
A
A
Drawing 2
M6 x 20
C
B
C
M5 x 16
Upper hinge
Bearing
Lower
hinge
Drawing 1
CHANGE BETWEEN RIGHT- AND
LEFT-HAND DOOR OPENING
If you want to change a door between
right- and left-hand opening, then we re-
quest you to kindly contact our factory,
tel. +358-3-5538600. We will send you a
mounting set and instructions on chan-
ging the opening direction.