Festivo Cooling Cabinet / Freezer Combination Instructions For Installation And Use Manual - page 7
7
FITTING THE SHELVES
The cooling cabinet has 4 shelves as
standard equipment. Put the left-hand
edge of the shelf into the groove
provided for it. Lower the right-hand
end of the shelf onto the support. Then
move the shelf to the right, so that the
shelf goes into its place. The wire
shelves are to be fitted so that the
raised edge is towards the back.
The bottle racks are to be fitted so that
they hang down under the shelf.
ADJUSTMENT OF THE DOOR
If it is necessary to adjust the doors, the
hinges can be adjusted to some degree
by loosing the fixing screws and moving
them in the directions of the arrows.
If the upper edges of the doors are at dif-
ferent levels (drawing 1), loosen the sc-
rews of the upper hinge. Turn the hinge in
a sideways direction (arrows C) until the
upper edges of the doors are at the same
level, and tighten the screws.
Dimension A (drawing 2) must be same
both up and down. If it is not, move the
upper hinge in B arrows direction.
Check also the seals of the doors.
If it is too compressed, move the upper
hinge outwards.
A
A
Drawing 1
Drawing 2
M6 x 20
Lower hinge
M5 x 16
B
C
C
Bearing
Bearing
Drawing 3
Upper hinge
If the seal has become pressed down,
warm it CAREFULLY with a hot-air blower
(hair dryer) and mould it with the fingers
to make it higher.
Note! If the door hinge is in the middle of
the cabinet, the protective cover on the
top must be released. Before the cover
will be released, the voltage of the applian-
ce must be switched off. Also the plug of
the appliance must be taken out of the
socket.
CHANGE BETWEEN RIGHT- AND
LEFT-HAND DOOR OPENING
If you want to change a door between
right- and left-hand opening, then we re-
quest you to kindly contact our factory,
tel. +358-3-5538600. We will send you a
mounting set and instructions on chan-
ging the opening direction.