Festool BS 105 Operating Instructions Manual - page 6
9
4.6
Stationary work on types BS 105 /
BS 105 E
(accessories type BS 105 E - Set)
When assembling the stationary support make
sure that the straight sides of the feet are
pointing inwards towards each other.
In order to be able to work safely, the feet must
be fastened to the supporting surface using
screw clamps.
The guide (accessories / 5.1) can be tilted up
to 45° according to scale for sanding of bevels.
5
Maintenance and care
When the graphite coating on the pad lining
(3.3) is heavily worn this has to be replaced.
To do this the 3 cheese-head screws (3.1) are
loosened and the strip (3.2) removed.
A sanding support for rough work at high rem-
oval rates is available.
The belt sander requires practically no
maintenance.
The lubrication for the antifriction bearings and
gears is designed to last for the service life of
the machine.
It is advisable to clean the air intake and outlet
ports and the dust suction and extraction
channel occasionally with compressed air while
the sander is running and at standstill.
This will prevent the openings from becoming
clogged with dust.
The special carbon brushes only wear down to
a minimum length.
Thereafter the power cuts out automatically and
the sander comes to a stop.
The motor housing may only be opened by an
authorised Festool service workshop, since
specialist knowledge is required for assembly.
6
Accessories
The accessory and tool order number can be
found in your Festool catalogue or on the
Internet under www.festool.com.
Sanding belts
- Resin-bonded X-cloth belts:
for finest wood sanding, machining of non-
ferrous and light metals, hardboards, iron and
sheet steel, deburring metals.
- Combination belts:
for removing paint and remains of concrete,
sanding plaster surfaces.
7
Warranty
Our equipment is under warranty for at least
12 months with regard to material or production
faults in accordance with national legislation.
In the EU countries, the warranty period is 24
months (an invoice or delivery note is required
as proof of purchase).
Damage resulting from, in particular, normal
wear and tear, overloading, improper handling,
or caused by the user or other damage caused
by not following the operating instructions, or
any fault acknowledged at the time of purchase,
is not covered by the warranty.
Complaints will only be acknowledged if the
equipment has not been dismantled before
being sent back to the suppliers or to an
authorised Festool customer support workshop.
Store the operating instructions, safety notes,
spare parts list and proof of purchase in a safe
place.
In addition, the manufacturers current
warranty conditions apply.
Note
We reserve the right to make changes to the
technical data contained in this information as
a result of ongoing research and development
work.
Seen at Ideal Tools.