Festool KS 60 E Original Operating Manual - page 25
KS 60 E
25
GB
Once the cut is complete, guide the saw unit
back to its upwards position.
The pendulum guard closes automatically.
Release the safety button and the On/Off switch.
Close the knob .
8.4
Sawing the mitre angle [10]
Standard mitre angle The following mitre angles
(left and right) automatically engage: 0°, 15°,
22.5°, 30°, 45°, 60°
Setting the standard mitre angle
Release the rotary knob
.
Press the detent lever but do not hook it into
place .
Rotate the rotary base into the required posi-
tion
; release the detent lever shortly before
the required angle has been reached.
The rotary base easily clicks into place at the in-
tended mitre angles.
Close the rotary knob
.
Setting individual mitre angles
Release the rotary knob
.
Press the detent lever
and let it click into
place by pressing on it at the left.
Continuously swivel the rotary base into the re-
quired position
.
Close the rotary knob
.
8.5
Sawing inclined cuts [11]
Moving or removing the stop rulers
may
make it necessary to implement special set-
tings for inclined cutting, see section 7.3.
Inclination to the left between 0° and 45°
Loosen the star handle
.
Tilt the saw unit to the desired cutting angle
.
Tighten the star handle
.
Inclination to the right between 0° and 45°:
Loosen the star handle
.
Press the release button
; if required, relieve
the tension by slightly tilting it in the opposite
direction.
Tilt the saw unit to the desired cutting angle
.
Tighten the star handle
.
46-47° inclination to the right/left (undercutting)
Loosen the star handle
.
Press the release button
; if required, re-
lieve the tension by slightly tilting it in the oppo-
site direction.
Tilt the saw unit to the limit stop
.
Press the release button again
.
Tilt the saw unit again
.
Tighten the star handle
.
8.6
Sawing grooves
The continuously adjustable groove depth limit can
be used to individually define groove areas using
the total cutting depth. Grooving or facing is there-
fore possible at any height for any workpiece size.
The round shape of the saw blade means that,
when grooving, a slight cutting curve upwards is
required. For grooving that is precisely horizon-
tal, a tap block must be clamped between the
workpiece and the stop ruler so that a clearance
of 4 cm can be guaranteed.
Move the machine into the working position.
Only turn down the lever for the groove depth
limit [1-4] if the saw unit is in the upper position
(= working position).
Pull the lever for the groove depth limit [1-4] to
the front.
The saw unit can now be pushed down only as
far as the preset cutting depth.
Turn the lever for the groove depth limit to set
the required depth (turn to the left = increase
the groove depth, turn to the right = decrease
the groove depth)
Push down the saw unit as a trial run to check
whether the groove depth limit is set to the required
groove depth.
Only push the saw unit down when the lever for
the groove depth limit has engaged in one of the
two end positions. Risk of damage to the power
tool.
Make the cuts.
To deactivate the groove depth limit, reset the
lever [1-4].
2
3
4
2
3
4
2
4
5
2
3
4
5
2
3
4
3
4
5