Fetco CBS-2100 XTS Users Manual And Operator Instructions - page 16
Go to fetco.com for the latest version of all information Part B
page 2
P130 partB REV 002 Technical Supplement March, 2016
Specifications and Requirements
Water Requirements:
Coffee Filter Size:
CBS-2140XTS: 20-75 psig, (138-517kPa) 1½gpm/(5.7lpm)
13” X 5”” – standard FETCO # F002
Water supplied to hot beverage equipment should be filtered
Water supplied Hardness >100 TDS (5.5 grain)
Electrical: See electrical configuration chart.
Water inlet fitting is a 3/8 inch male flare.
Temperature, as set by factory:
Brew Volume: Full Batch Up to 1 gallon/3.8 liters per brew
200°F (93°C) inside water tank (at sea level)
Total Brew Cycle—Factory setting: 5.5 minutes=[4 minute brew time + 1.5 minute drip delay]
.
Specifications-Electrical and Output Configurations
For qualified service technicians
These specifications apply to FETCO CBS-2141XTS & CBS-2142XTS manufactured as of January 2016
CBS-2140XTS USA and Canada
CBS_2142XTS—Twin
Single-Voltage
Configuration
Code
Heater
Configuration
Voltage Phase Wires
Electrical
Connection
KW
Amp
Draw
Brew-Volume/Hour
(3 liters per batch)
E214251
2 X 3.0 kW
200-240
1
2+G
Terminal Block
6.1
25.5 14.0 gal/53 liters
Please see wiring diagrams located in back pages for installation notes.
..
CBS_2141XTS—Single Field configurable, Dual-Voltage Three wire plus ground electrical
Configuration
Codes
Heater
Configuration
Voltage Phase Wires
Electrical
Connection
KW
Amp
Draw
Brew-Volume/Hour
(3 liters per batch)
E214171
1 X 1.5 kW
120
1
2+G
NEMA 5-15P
1.6 13.0 3.9
gal/14.8liter
(*Optional)
2 X 1.5 kW (120/208-240)
1
(3+G)
Hardwire
L1,L2,N+G
3.1
13.0
7.7 gal/29.5 liter
E214172
1 X 1.7 kW
120
1
2+G
NEMA 5-15P
1.8
14.7
4.4 gal/16.7 liter
(*Optional)
2 X 1.7 kW (120/208-240)
1
(3+G)
Hardwire
L1,L2,N+G
3.5
14.7
8.7 gal/33 liter
E214173
1 X 2.3 kW
120
1
2+G
NEMA 5-20P
2.4
19.7
5.8 gal/22 liter
(*Optional)
2X 2.3 kW (120/208-240)
1
(3+G)
Hardwire
L1,L2,N+G
4.7 19.7 11.0gal/41.6
liter
*
Sold with factory cord & plug for 120 Volt configuration. Optional user connection to a terminal block requiring L1, L2, N and ground to120/208-240 VAC
User selectable for optional, dual in-series heater configuration: DO NOT WIRE L2 to nuetral. The optional configuration requires three wire plus ground.
.SEE WIRING DIAGRAMS AT BACK OF THIS GUIDE
.
CBS-2141XTS From Factory
120 volt models
CBS-2141XTS *Field installed option
120/208-240 volt models
CBS-2142XTS 208-240 volt
All CBS 2141XTS
OPTIONAL 2 HEATER ONLY
SKU E214171, E214172; E214173
As supplied from factory
SKU E214171, E214172; E214173
As optional user configuration
SKU E214251
G
W
G
W
NEMA PLUG CONFIGURATION
NEMA 5-15P NEMA 5-20P