Fetco CBS-51H10 User Manual - page 11

11

Mechanical Illustration - Dispense System 

STOP

BREW

SIDE (SECTION) VIEW

FRONT VIEW

BREW BASKET

CONTROL PANEL

HOT WATER TANK

DISPENSE TUBE

SPRAY HEAD

BY-PASS TUBE

FLOW DISC

SPRAY CUTTER

LOCKNUT

BY-PASS VALVE

DISPENSE LATCH ASSEMBLY:

SOLENOID ASSY, PUSH ROD, MICROSWITCH,

SOLENOID LATCH PLATE ASSY

WATER LEVEL PROBE

BREW START/STOP HANDLE

BREW START/STOP

HANDLE RETURN

SPRING

DISPENSE FITTING ASSY:

DISPENSE FITTING

DISPENSE FITTING LOCKNUT

SEAL

SEAL LOCKNUT

TEFLON SEAL

SEAL LOCKNUT

TEFLON SEAL

SPRAY HEAD

DRIVE SCREW

DISPENSE TUBE SHAFT

DISPENSE TUBE

To remove the dispense tube: 

1.  Unscrew seal locknut and 

release the drive screw from 

dispense tube shaft. 

2.  Turn the dispense tube 

slightly back and forth,  while 

pushing the tube into the hot 

water tank until it is free from 

the sprayhead. 

Pull the dispense tube out of 

the tank. Remember the tube 

is bent inside the tank. The 

seal will come out with the 

tube. 

To install the dispense tube: 

1.  Clean any lime build up off 

the tube and then slide the seal

off. Push the seal  carefully 

into its chamber in the 

fitting.(spring towards the hot 

water tank.) 

2.  Place the seal locknut onto 

the tube and slide the tube into 

the seal. Tighten the seal 

locknut. 

3.  Work the tube back into 

the sprayhead seal. 

4.  Join the dispense tube 

shaft and the brew handle 

shaft with the drive screw.