Fetco CBS-51H10 User Manual - page 21

21

LUXUS Server Problem 

Possible Cause 

Solution 

LUXUS leaking from the base 

Overflow of coffee, or water from 

cleaning running down the side and 

collecting in the black plastic base 

(1.5 gallon LUXUS only) 

-Remove the plastic base (it slips on and off) wipe the 

interior and plastic base dry and reassemble. Monitor brew 

practices & do not clean containers in sinks or dishwashers 

Bad O-ring gasket behind faucet 

shank 

(1.5 & 3 gallon LUXUS) 

-Remove the faucet, then unbolt the faucet shank from the 

LUXUS and replace the O-ring. 

LUXUS leaking from sight gauge 

Brew level set too high 

-Adjust timers for proper level 

Sight gauge cap not tight 

-Tighten gauge cap (show operators how this could have 

been loosened when the vent cap was opened) 

Lower gasket missing or bad 

-Replace and or discourage casual cleaning practices 

Coffee not hot enough 

LUXUS not preheated before first 

brew of the day 

-Preheat the LUXUS 1/2 full with hot water and let stand for 

15 minutes 

Attempting to hold coffee too long. 

-Review discard times 

Using 1/2 batch on regular basis 

-Encourage full batch use except at end of day or shift. 

Explore the need for smaller brewers 

Judging temperature from a sample 

that is too small, taken from an 

infrequently used LUXUS 

-A small amount of coffee in the faucet body will cool in 

about 15 minutes. 

Drip from faucet 

Blockage in faucet 

(hair from cleaning brush, coffee 

oils, etc.) 

-Remove faucet bonnet (top part with handle attached) and 

clean seat cup and faucet body. Clean on regular basis 

Faucet seat cup  

-Remove faucet bonnet (top part with handle attached) and 

replace seat cup. Stained cups are OK cracked or brittle 

are not. 

Coffee won’t dispense 

Vents closed on top of gauge tube 

and or twist lock cover 

-Open vents (vents are closed only for transporting the 

servers or to extend holding times prior to serving coffee)