Fetco GR-1.2 User Manual - Installation

3

Dimensions & Utility Connections 

Installation 

Warning: Read this User’s Guide before installing. Damage caused by improper installation will not be 

covered under warranty. 

1.  Inspect the container for visual or hidden damage. The carrier must be notified of any punctured or 

damaged cartons immediately.   

2.  Install the grinder in selected location making sure surface is level, and that grinder will fit. 

Caution: Never 

push equipment against cords or wall outlets.

3.  Remove cord from inside hopper and plug into the back of the grinder.  

4.  Before plugging grinder into 120 volt, 15 amp. wall outlet make sure 

outlet is not overloaded, a dedicated circuit is preferred.  

5.  Following the operating procedures below test grinder for proper 

operation. 

6.  If you need further assistance please call our Technical Support 

Dept. at 800-338-2699 or e-mail  techsupport@fetco.com. 

Warning: To prevent 

                 electrical shock, this 

                 unit must be properly 

                 grounded.