1. DL manuals
  2. Fetco
  3. Water Dispenser
  4. HWB-2102 series
  5. User Manual

Fetco HWB-2102 series User Manual

Manual is about: Hot Water Dispenser

Summary of HWB-2102 series

  • Page 1

    Fetco®, xts are trademarks or trade names of food equipment technologies company. © 2014 food equipment technologies company p134 - ce edition november 2014 notice to installer: please leave this book with the machine. Www.Fetco.Com user’s guide hw b-2102 series commercial hot water dispensers table...

  • Page 2

    2 fetco hot water dispenser hwd_2102 contact information fetco ® food equipment technologies company 600 rose road lake zurich • il • 60047-0429 • usa internet: www.Fetco.Com phone: (800) 338-2699 (us & canada) (847) 719-3000 fax: (847) 719-3001 email: sales@fetco.Com techsupport@fetco.Com descripti...

  • Page 3

    3 control panel layout diagram for hwd_2102 hot water dispenser power lamp (lit when unit is energized) ready lamp -dispense will operate when lit, -temperature is low when not lit heating lamp for hot water tank (is “on” when heater is activated) sensor for function selector selects and activates s...

  • Page 4

    4 user cleaning & maintenance daily: 1. Check the drip tray and empty if necessary. Quarterly: 2. Inspect all fittings and hoses for leaks. Notice: 3. Turn off power before any cleaning procedure, including wiping the exterior for appearance reasons. Dry the exterior, especially the face panel, befo...

  • Page 5

    5 specifications for qualified service technicians . Export and ce-electrical configurations configuration code heater configuration voltage phase wires electrical connection w maximum amp draw flow rate per hour* h210240ce 1 x 3.2 kw 230 single l ,n, pe 3030 13.8 31.0 liters/8.2gal *flow rate based...

  • Page 6

    6 installation the installation must comply with applicable federal, state, and local codes having jurisdiction at your location. Utilize only qualified beverage equipment service technicians for installation. A service company directory may be found on our website, http://www.Fetco.Com. Setup 1. Be...

  • Page 7

    7 2 1 3 to remove: pull silicone tap guard down 1) to access setting controls open the cover panel correction for altitude to access controls 1) remove lower face panel first, 2) upper face panel next, 3) top panel last access the dials of the three rotary switches dials are marked s3 th (temperatur...

  • Page 8

    8 ready [green] heater [white] touch pad [red] error messages the unlock/dispense pad rapidly flashes red if finger remains on it after dispensing and no water is dispensed. If finger remains on the unlock/dispense pad more than 35 seconds while rapidly flashing red-the controls “lock out” and ready...

  • Page 9

    9 ready [green] heater [white] touch pad [red] table of technical data sw1 = time * 10 sw3=temperature set sw2 = time * 1 0 = 87 c 1 = 88 c 2 = 89 c 3 = 90 c 4 = 91 c 5 = 92 c 6 = 93 c 7 = 94 c 8 = 95 c portion time = sw1 * 10 + sw2 min time = 1 second even if sw1 and sw2 are set to 0 max time is 30...

  • Page 10: Operating Principles

    10 operating principles the dispense valve assembly delivers precision temperature water at selected temperatures. When hot water is drawn from the faucet, the fill valve pulses on and off every few seconds to replenish the tank. By controlling the flow of incoming water, the amount of cold water en...

  • Page 11

    11 installation safety and hygiene directions 1. Access to the service area is restricted to persons having safety/hygiene knowledge and practical experience of the coffee brewer. This appliance must be installed in locations where it can be overseen by trained personnel 2. For proper operation, thi...

  • Page 12

    12 for back panel of equipment warning to reduce risk of electric shock or fire fetco® hot beverage equipment is for commercial use only. Do not remove or open cover. No user serviceable parts inside. Refer installation and service to qualified personnel. Caution, disconnect from power supply before...