FG Flight T53 Owner's Manual - page 6
TIPS
To stop filming, please press the camera button on the remote control. If you
unplug the battery cable or take out the TF memory card from the camera module it
will result in the loss of the video data.
To avoid helicopter crashing,please do not insert or take out the TF memory card from
the camera module,whilst the helicopter is on. The TF memory card should be installed
before the helicopter is on and taken out only when off.
If you crash turn the helicopter off and then turn back on to recover the helicopter.
When the red light and the green light on the camera keep flashing
alternately, it means that the TF memory card is not inserted or the TF memory card is
damaged. It is possible to restore the memory card by reformatting(Take out the TF
memory card, then, insert it into the USB card reader, then, connect it to the computer
and reformat the memory card)
If the red light remains "ON" this indicates insufficient memory.
1. Use a wet cloth to clean this product.
2. Avoid exposure to sunlight and extreme temperatures.
3. Do not soak in water.
4. Switch off the remote control and the helicopter when not using.
5. Batteries should be taken out of the controller when not being used for some time.
6. Use all new alkaline batteries for the helicopter to have the best performance.
7. Periodically check the plugs and other parts of the helicopter for damage. If
damage is found do not use until it has been repaired.
The channel of the
controller is not the same
as the helicopter.
Charge the helicopter battery.
controller.
Unable to
control the
helicopter
correctly
1. Too much sunlight.
2. Another Controller nearby is
on the same frequency.
Choose a better place out of
direct sunlight.
Change the switch on the
controller to a different infra red
channel.