Foxtech SEEKER-18 User Manual - page 4
Notice
1.The input voltage only supports 4S ~ 6S.
2.There are about 2 seconds for self-inspection after the pod is power-on.
When the sound is heard, the self-inspection is completed. Please do not shake
the pod in the self-inspection process. If the inspection fails (for a long time there
is no beep), please turn on the power again.
3. HDMI default outputs the visible light camera video signal,AV default
outputs the infrared camera video signal.
4. The video switch control: the switching control from the mid-position to low
position and then back to the mid-position can change the visible light and infrared
camera video signal; the switching control switch from the mid-position to the top
and then back to the mid-position is the palette switch of infrared camera .
5. In the default state, the zoom control is the white light camera zoom
control. When the video switch control cutting from the mid-position to high-
position (and ultimately stay at the high-position) 2S later, the zoom control will
be the infrared camera electronic zoom control.
6.The mid-level of white light video camera control is the standby position;
the control is switched from the mid-position to high-position and then back to
the mid-position can switch the camera mode, and the camera mode includes the
video mode and camera mode. The acting switch from mid-to low position can
trigger a video (photo) command .
7.The mid-position of infrared video camera photo control is the standby
position, switch to low-position can trigger the video, and switch to the high-
position and then back to the middle-position can trigger the camera.
8.Shut off the power before you will stop the video , otherwise the video will be
damaged.
9. The users are not allowed to disassemble and modify the optoelectronic
pod. Once the user disassembles or modifies by themselves, it is deemed to
automatically give up the right to after-sales service, and the losses caused by it,
our company does not undertake any responsibility.
10.Our company reserves the right to modify the product parameters,
performance and other information, so there is no notice of change.
Installation dimensions