Foxtel iQ2 User Manual - Power Macro
19
POWER Macro
When in AV Mode, the Foxtel iQ2 Remote is able to be programmed with
codes that enable it to control the power of the television or amp/tuner or
DVD/VCR. When in FOXTEL mode it will control the power of the FOXTEL iQ2. If
more than one device code is programmed into the FOXTEL iQ2 Remote it is
possible to have the FOXTEL iQ2 Remote the power function of all three devices
in sequence when the ppoow
weerr button is pressed. This function is called Power
Macro.
To activate the Power Macro:
11..
Press aavv button on the FOXTEL iQ2 Remote.
22..
Press and hold the sseelleecctt button, then press and hold the rreedd button. Keep
both buttons held down until the LED on the FOXTEL iQ2 Remote flashes
twice
33..
Press 99 99 55.
44..
Press the ppoow
weerr button.
55..
Press aavv button.
66..
Press sseelleecctt, the LED will flash twice.
77..
When Power Macro is set the ppoow
weerr button sends the power function of all
devices programmed in the sequence of: television, amp/tuner, VCR/DVD.
When television, amp/tuner and/or VCR/DVD codes have been programmed
and the Power Macro feature has been enabled, the ppoow
weerr button will send
the power function for all devices with one press of the ppoow
weerr button. Should
you wish to exclude a device from the Power Macro function, perform the fol-
lowing steps:
11..
To exclude the Power Macro from controlling the power function of
your television press and hold the sseelleecctt button then also press the 77
button.
22..
To exclude the Power Macro from controlling the power function of
your amp/tuner press and hold the sseelleecctt button then also press the
88 button.
33..
To exclude the Power Macro from controlling the power function of your
VCR/DVD press and hold the sseelleecctt button then also press the 99 button.
44..
To exclude the Power Macro from controlling the SSEELLEECCTT button and
also press the 44 button"
Note: If the Power Macro is not set, the > will perform power
allocation
Note: Power Macro can be used with Power Allocation to enable programmed
devices to be switched on/off when the FOXTEL iQ2 Remote Control is in
FOXTEL mode
To deactivate the Power Macro:
11..
Press aavv button on the FOXTEL iQ2 Remote.
22..
Press and hold the sseelleecctt button, then press and hold the rreedd
button. Keep both buttons held down until the LED on the FOXTEL iQ2
Remote flashes twice
33..
Press 99 99 55.
44..
Press the ppoow
weerr button.
55..
Press the ppoow
weerr button again.
Hint: When using the Power Macro the on/off states of your devices can
become unsynchronised, that is the television might be on but the amp/tuner
off – pressing the ppoow
weerr button will turn the television off but the amp/tuner
on. This is because on most devices the power function is a toggle, the same
command turns the device on as turns the device off. To overcome this, cover
the front of the FOXTEL iQ2 Remote with your hand when it is sending to the
device you don’t want to change. The Power Macro first send the command to
the television then the AMP/TUNER then the VCR/DVD, the three commands
are sent about half a second apart.
FOXTEL_F120_New_RDN-2310708:FOXTEL_PVR_opmaak 31-07-2008 16:15 Pagina 19