Foxun SX-EH100 Operating Instructions - page 4
Operating Instructions
Receiver Panel
1
HDBaseT port
2
IR-RX port
3
IR-TX port
4
RS232 port
5
Status of HDCP
6
Status of signal connection
7
Status of Mode
8
Indicator of power input
9
Power input port
10
HDMI Output
11
Ethernet ports
4444
Operating Instructions
POWER
POWER
POWER
POWER: indicates that power is available to the unit.
MODE
MODE
MODE
MODE : when blinking indicates the device is active (fw running).
LINK
LINK
LINK
LINK : when ON indicates that an HD Base-T
TM
link connection has been established between the two
boards over the CAT5e cable.
HDCP
HDCP
HDCP
HDCP : when ON, indicates that video content with HDCP protection is being transferred. When
BLINKING, indicates video content without HDCP. When OFF,indicates that no video is being transferred.
CONNECTING
CONNECTING
CONNECTING
CONNECTING AND
AND
AND
AND OPERATING
OPERATING
OPERATING
OPERATING
1) Connect the HDMI signal sources (Such as DVD, STB etc) to HDMI Transmitter.
2) Connect Fiber cables to both fiber port of the transmitter and fiber port of the Receiver.
3) Connect the HDMI output (Such as HD-LCD, HD-DLP) into the Receiver.
4)
Connect the power supply into
Power port.
5) Connect the IR TX receiving cables into IR TX port on the back panel and affix the emitter onto the
source IR windows.
6) Connect IR-RX cable into IR-RX port on the receiver and affix the IR receiver in direct line of site
with the handheld remote control.It is recommended to affix the receiver on the display frame /bezel
or the display stand.
Attention: Insert/Extract cables gently.
TYPICAL APPLICATION
5555