1. DL manuals
  2. FPI
  3. Indoor Fireplace
  4. E33-LP1
  5. Owners & Installation Manual

FPI E33-LP1 Owners & Installation Manual

Manual is about: fireplace

Summary of E33-LP1

  • Page 1

    Fpi fireplace products international ltd. 6988 venture st., delta, bc, canada v4g 1h4 918-513b warning: improper installation, adjustment, alteration, service or maintenance can cause injury, property damage, or loss of life. Refer to this manual. For assistance or additional information consult an ...

  • Page 2

    2 e33 fpi direct vent gas insert fpi gas fireplace insert to the new owner congratulations! You are the owner of a state-of-the-art gas insert by fpi. The e33 gas insert has been designed to provide you with all the warmth and charm of a fi replace, at the fl ick of a switch. The e33-ng1 and e33-lp1...

  • Page 3: Table of Contents

    3 e33 fpi direct vent gas insert table of contents operating instructions first fire ......................................................................26 operating instructions .................................................26 lighting procedure ...................................................

  • Page 4: Safety Label

    4 e33 fpi direct vent gas insert safety label this is a copy of the labels that accompany each e33 gas insert. We have printed a copy of the contents here for your review. The safety label is located on a plate inside the base of the unit visible when the bottom louver is opened. Ensure that the saf...

  • Page 5: Requirements

    5 e33 fpi direct vent gas insert requirements 5.08: modifications to nfpa-54, chapter 10 (2) revise 10.8.3 by adding the following additional requirements: (a) for all side wall horizontally vented gas fueled equipment installed in every dwelling, building or structure used in whole or in part for r...

  • Page 6: Installation

    6 e33 fpi direct vent gas insert important message save these instructions the fpi gas insert must be installed in accord- ance with these instructions. Carefully read all the instructions in this manual fi rst. Consult the building authority having jurisdiction to determine the need for a permit pr...

  • Page 7: Installation

    7 e33 fpi direct vent gas insert 11) due to high temperatures, the appliance should be located out of high traffi c areas and away from furniture and draperies. Children and adults should be alerted to the hazards of high surface temperatures, especially the fi replace glass, and should stay away to...

  • Page 8: Installation

    8 e33 fpi direct vent gas insert minimum clearances to combustibles from unit side walls * a 8" (203 mm) ceiling b 47" (1194 mm) min. Mantel height c 15" (381 mm) max. Mantel depth d 3-1/2" (89 mm) alcove width e 76" (1930 mm) alcove depth f 36" (914 mm) hearth height g 1-1/4" (32 mm) hearth width h...

  • Page 9: Installation

    9 e33 fpi direct vent gas insert note: this unit is equipped with a heat sensor thermodisc which will prevent the blower from operating until the unit reaches the correct temperature. Venting the appliance must not be connected to a chimney flue serving a separate solid fuel burning appliance. This ...

  • Page 10: Installation

    10 e33 fpi direct vent gas insert optional brick panel optional brick panel set: part # description qty top (brick) panel 1 back (brick) panel 1 left (brick) panel 1 right (brick)panel 1 340-043 top bracket 1 340-094 bottom clips 2 511-031 brick clips 2 gas pipe pressure testing the appliance must b...

  • Page 11: Installation

    11 e33 fpi direct vent gas insert diagram 1 installation of brick panels: 1) remove top louver and glass door if installed. 2) remove the logs if they are already installed. Note: the grate must be removed in order to remove the bottom log. Ensure you slide the bottom coal off to the right-hand side...

  • Page 12: Installation

    12 e33 fpi direct vent gas insert installation gas log kit #340-930 contains the following: 03-17 bottom log 03-18 center top log 03-19 front log 03-20 left log 03-21 right log 03-22 left top log 03-23 rear log 03-24 right top log 946-669 platinum embers (supplied in packaged manual) warning: danger...

  • Page 13: Installation

    13 e33 fpi direct vent gas insert installation 7) align the bottom grooves of log 03-21 onto the right side of the grate and gently slide the log back until it touches the locating tab (refer to diagram 4 & 5). Diagram 4 locating tab 03-23 03-17 03-21 diagram 5 8) align and position the pin hole of ...

  • Page 14: Installation

    14 e33 fpi direct vent gas insert 03-17 03-20 03-23 03-22 03-18 diagram 10 11) place log 03-24 over log 03-23 and log 03-21 ensuring the pin hole of log 03-24 lines up with the right pin of log 03-23 and the right pin of log 03-21 (refer to diagram 11). 03-24 03-23 03-21 locating pins diagram 11 12)...

  • Page 15: Installation

    15 e33 fpi direct vent gas insert each kit contains one lpg conversion kit and one dc sparker kit. Lpg conversion kit contains: qty. Part # description 1 904-529 5/32" allen key 1 904-641 burner orifi ce #50 1 918-590 label "converted to lpg" 1 908-528 red lpg label 1 910-037 lpg injector (pilot ori...

  • Page 16: Installation

    16 e33 fpi direct vent gas insert warning! Do not over tighten the screw. Recommended to grip the wrench by the short side. 15) using the allen wrench as shown in fig.4, rotate the screw clockwise until snug, do not overtighten. Fig.4 16) verify that if the conversion is from ng to lpg, the screw mu...

  • Page 17: Installation

    17 e33 fpi direct vent gas insert 31) locate the ground lug at the receptical box, left of the unit. 32) connect one end of the supplied green ground wire to the lug with the nut and washer from the kit. 33) install the 1/2" bushing to the heat shield. Ground wire from kit 35) plug the dc spark gene...

  • Page 18: Installation

    18 e33 fpi direct vent gas insert diagram 5 11) push the fpi logo plate into the two holes in the bottom left corner of the faceplate. 10) attach the faceplate panels to the insert body using the 4 remaining black screws. Refer to diagram 5. Diagram 4 9) attach the trim to the faceplate by using the...

  • Page 19: Installation

    19 e33 fpi direct vent gas insert contemporary faceplate & door frame installation 1) bring the faceplate up in front of the unit and connect the red & black on/off wires from the unit to the on/off switch on the back of the left side of the faceplate. 2) connect the grey coated female ends of the b...

  • Page 20: Installation

    20 e33 fpi direct vent gas insert installation 6) place 2 screws through the screw holes on the hinge and place a spacer over each screw. 7) secure the hinge to the bottom fl ange of the fi rebox with 2 screws from step 6. Repeat for other side. Screw spacer 8) align the left and right side hinge wi...

  • Page 21: Installation

    21 e33 fpi direct vent gas insert the standard fl ush door comes with a black frame. To install the frame, simply hook the top door fl ange onto the top of the unit and swing the door towards the unit, (diagram 1 and 2). Be careful that the glass gasket does not roll up; there must be a gap between ...

  • Page 22: Installation

    22 e33 fpi direct vent gas insert 1) align the left side faceplate trim bracket with the firebox flange and secure using 2 screws as shown in diagram 1. Repeat for right side. Faceplate trim bracket firebox flange important note: when using the surround, the unit must be set 1" further into the fi r...

  • Page 23: Installation

    23 e33 fpi direct vent gas insert 1) remove the rivets from the surround by pulling off the hoseclamp (located at the backside of surround) with a screwdriver or plyer. Re-install the rivets by putting them through the holes on the sides of the sur- round. 3) remove the handles by removing the nut a...

  • Page 24: Installation

    24 e33 fpi direct vent gas insert wiring diagrams this heater does not require a 120v a.C. Supply for operation. However, a 120v a.C. Power supply is needed for the fan/blower operation. Warning: electrical grounding instructions this appliance is equipped with a three pronged (grounding) plug for y...

  • Page 25: Installation

    25 e33 fpi direct vent gas insert use the fpi remote control kit approved for this unit. Use of other systems may void your warranty. The remote control kit comes with a hand held transmitter, a receiver and a wall mounting plate. 1) choose a convenient location on the wall to install the receiver a...

  • Page 26: Operating Instructions

    26 e33 fpi direct vent gas insert important: gas on/off knob cannot be turned from "pilot" to "off" unless it is partially depressed. 1) turn burner off using "on/off" switch. 2) turn gas control knob so indicator points to "off" position and allow 5 minutes for any gas in the combustion chamber to ...

  • Page 27: Operating Instructions

    27 e33 fpi direct vent gas insert operating instructions copy of lighting instruction plate automatic convection fan operation the fan operates automatically. Turn the knob on the side of the faceplate to adjust to the desired speed. The fan will turn on as the stove comes up to operating temperatur...

  • Page 28: Maintenance

    28 e33 fpi direct vent gas insert maintenance general vent maintenance conduct an inspection of the venting system semi-annually. Recommended areas to inspect as follows: 1) check the venting system for corrosion in areas that are exposed to the elements. These will appear as rust spots or streaks, ...

  • Page 29: Maintenance

    29 e33 fpi direct vent gas insert maintenance fan maintenance if your fan requires maintenance or replacement, access to the fan is through the plate on the fl oor of the fi rebox. Note: the unit must not be operated without the fan access panel securely in place. Caution: label all wires prior to d...

  • Page 30: Maintenance

    30 e33 fpi direct vent gas insert maintenance 11) disconnect the inlet gas line. 12) unplug the black and red wires at the valve. Undo the 2 tp wires at the valve. 13) remove the 17 screws on the valve tray. 14) take out the valve tray from the unit. 15) scrape off the old gasket from the fl oor of ...

  • Page 31: Parts List

    31 e33 fpi direct vent gas insert parts list main assembly part # description 1) 340-038 fan access plate 2) 340-103 gasket - fan access plate 3) 320-517/p fan assembly 120 v 910-331/p fan motor 120 v 5) 910-750 power cord 910-752 wire harness (faceplate) 910-692 wire fan to power cord 910-737 wire ...

  • Page 32: Parts List

    32 e33 fpi direct vent gas insert parts list burner & log assembly part # description 52) 340-104 gasket - valve tray 340-574/p valve assembly - ng 340-576/p valve assembly - lp 56) 910-190 piezo ignitor and nut 57) 910-478 valve - s.I.T. - natural gas / propane 59) * valve tray 910-034 pilot assy-3...

  • Page 33: Parts List

    33 e33 fpi direct vent gas insert 83 84 85 86 87 88 88 88 88 89 90 90 full screen front part # description parts list 83) * top frame 84) 340-910 full screen door - black 85) * full screen left door 86) * full screen right door 87) * bottom frame 88) * screw #8 x 1/2 self tapping 89) 910-199 wire cl...

  • Page 34: Parts List

    34 e33 fpi direct vent gas insert parts list faceplates, trims and hearths part # description part # description 340-918 faceplates and trim (complete) w/ black trim 340-919 oversized faceplate 74) 904-569 fan speed control knob 91) * faceplate side - right 92) * faceplate - top 93) * faceplate side...

  • Page 35: Parts List

    35 e33 fpi direct vent gas insert contemporary faceplate & door frame part # description 341-914 contemporary faceplate & door frame 90) * complete faceplate 91) * door frame 92) * bottom louver 93) * hinges 910-246 burner on/off switch 910-330 fan speed control 120v 904-569 fan speed control knob *...

  • Page 36: Notes

    36 e33 fpi direct vent gas insert notes ___________________________________________________ ___________________________________________________ ___________________________________________________ ___________________________________________________ ___________________________________________________ ...

  • Page 37: Notes

    37 e33 fpi direct vent gas insert notes ___________________________________________________ ___________________________________________________ ___________________________________________________ ___________________________________________________ ___________________________________________________ ...

  • Page 38: Notes

    38 e33 fpi direct vent gas insert notes ___________________________________________________ ___________________________________________________ ___________________________________________________ ___________________________________________________ ___________________________________________________ ...

  • Page 39: Warranty

    39 e33 fpi direct vent gas insert warranty regency fireplace products are designed with reliability and simplicity in mind. In addition, our internal quality assurance team carefully inspects each unit thoroughly before it leaves our facility. Fpi fireplace products international ltd. Is pleased to ...

  • Page 40: Our Door.

    Installer: please complete the following information dealer name & address: ______________________________________________ ___________________________________________________________________ installer: ___________________________________________________________ phone #: _____________________________...