1. DL manuals
  2. FPI
  3. Stove
  4. Hampton H200
  5. Owners & Installation Manual

FPI Hampton H200 Owners & Installation Manual

Manual is about: Freestanding Woodstove

Summary of Hampton H200

  • Page 1

    Fpi fireplace products international ltd. 6988 venture st., delta, bc canada, v4g 1h4 918-427a model: h200 freestanding woodstove 10/25/11 installer: please complete the details on the back cover and leave this manual with the homeowner. Homeowner: please keep these instructions for future reference...

  • Page 2

    2 hampton h200 cast freestanding woodstove thank-you for purchasing a hampton fireplace product. The pride of workmanship that goes into each of our products will give you years of trouble-free enjoyment. Should you have any questions about your product that are not covered in this manual, please co...

  • Page 3: Table of Contents

    Hampton h200 cast freestanding woodstove 3 3 table of contents safety label safety label...................................................................4 unit dimensions unit dimensions with standard legs.............................5 unit dimensions with optional short legs ....................6...

  • Page 4: Safety Label

    4 hampton h200 cast freestanding woodstove safety label this is a copy of the label that accompanies each hampton h200 freestanding woodstove. We have printed a copy of the contents here for your review. Note: hampton units are constantly being improved. Check the label on the unit and if there is a...

  • Page 5: Dimensions

    Hampton h200 cast freestanding woodstove 5 dimensions unit dimensions with standard legs.

  • Page 6: Dimensions

    6 hampton h200 cast freestanding woodstove dimensions unit dimensions with optional short legs.

  • Page 7: Installation

    Hampton h200 cast freestanding woodstove 7 installation pre-installation assembly after removing the stove from its packing, open the front door and remove the contents from the fi rebox, leaving the bricks in place. Rotating elbow this stove can be connected to either a top or rear vent exit by sim...

  • Page 8: Installation

    8 hampton h200 cast freestanding woodstove installation residential installation 1) please read this entire manual before you install and use your new woodstove. Failure to follow instructions may result in property damage, bodily injury or even death. Be aware that local codes and regulations may o...

  • Page 9: Installation

    Hampton h200 cast freestanding woodstove 9 installation residential installation “c” vent (single wall) unit (with heat shield) from unit from from flue center-line corner a b c d e f h200 17" (431 mm) 15" (381 mm) 13" (330 mm) 29" (737 mm) 17-1/8"(435 mm) 19-7/8" (505mm) residential close clearance...

  • Page 10: Installation

    10 hampton h200 cast freestanding woodstove installation minimum alcove clearance to combustible materials this hampton freestanding model has been alcove approved and must be installed with a listed double wall connector to the ceiling level. Note: minimum alcove ceiling height (from fi nished fl o...

  • Page 11: Installation

    Hampton h200 cast freestanding woodstove 11 installation floor protection note: in canada, fl oor protection must extend 18" (450mm) to the front and 8" (200mm) to each side and back of the stove. Minimum overall depth (y) of floor protector residential residential mobile home alcove unit "c" vent c...

  • Page 12: Installation

    12 hampton h200 cast freestanding woodstove installation horizontal installation standard ceiling installation note: increasing the chimney height above this minimum level will sometimes help your unit to “breathe” better by allowing a greater draft to be cre- ated. This greater draft can decrease p...

  • Page 13: Installation

    Hampton h200 cast freestanding woodstove 13 installation masonry fireplace there are listed kits available to connect a stove to a masonry fi replace. The kit is an adapter that is installed at the location of the fi replace damper. The existing damper may have to be removed to allow installation. M...

  • Page 14: Installation

    14 hampton h200 cast freestanding woodstove installation method a : 12" (304.8 mm) clearance to combustible wall member: using a minimum thickness 3.5" (89 mm) brick and a 5/8" (15.9 mm) minimum wall thickness clay liner, construct a wall pass-through. The clay liner must conform to astm c315 (stand...

  • Page 15: Installation

    Hampton h200 cast freestanding woodstove 15 installation recommended heights for woodstove flue simple rules on draft. See table 1. 1) at sea level minimum height is 12' straight. 2) add the following vertical height to compen- sate for: 45 deg. Elbow = 1 ft. 90 deg. Elbow = 2 ft. "t" = 3 ft. Each f...

  • Page 16: Installation

    16 hampton h200 cast freestanding woodstove installation mobile home installation once you have properly marked the position of your unit and the fl oor protection as outlined in the residential installation items #1 through #8, a supply of fresh air has to be supplied to your unit. Place your unit ...

  • Page 17: Installation

    Hampton h200 cast freestanding woodstove 17 installation ameri-techs qty.Part # description 1 6dcc connector 1 6hsrs-12 roof support (6plrs-12-bk) 1 6f flashing 1 6hs-36 chimney length 1 6hs-18 chimney length 1 6hs-rcs rain cap (6pl-mpc) simpson dura-plus qty.Part # description 1 6dvl8693 connector ...

  • Page 18: Installation

    18 hampton h200 cast freestanding woodstove installation door removal brick installation firebrick is included to extend the life of your stove and to radiate heat more evenly. Check to see that all fi rebricks are in their correct positions and have not become misaligned during shipping. Spring lev...

  • Page 19: Installation

    Hampton h200 cast freestanding woodstove 19 installation caution: label all wires prior to disconnection when servicing controls. Wiring errors can cause improper and dangerous operation. Warning: electrical grounding instructions this appliance is equipped with a three pronged (grounding) plug for ...

  • Page 20: Installation

    20 hampton h200 cast freestanding woodstove installation 1) secure 2 support gussets to each side shelf using 2 screws per gusset. 2) secure the brackets to the middle of the side shelves using 2 screws and washers. 4) mount side shelf to stove and secure in place using the allen key provided to sec...

  • Page 21: Installation

    Hampton h200 cast freestanding woodstove 21 installation 1) remove the andirons and bricks from within the fi rebox. Andiron 2) remove bottom tray by undoing the 4 bolts. Bricks 3) remove the ash dump cover plates (one inside the fi rebox and one on the underside of the fi rebox) by removing the 2 n...

  • Page 22: Operating Instructions

    22 hampton h200 cast freestanding woodstove 22 operating instructions 13) all fuel burning appliances consume oxygen during operation. It is important that you supply a source of fresh air to your unit while burning. A slightly opened window is suf fi cient for the purpose. If you also have a fi rep...

  • Page 23: Installation

    Hampton h200 cast freestanding woodstove 23 23 installation operating instructions safety guidelines and warnings 1) never use gasoline, gasoline type lantern fuels, kerosene, charcoal lighter fuel, or similar liquids to start or ‘freshen up’ a fi re in your heater. Keep all such liquids well away f...

  • Page 24: Operating Instructions

    24 hampton h200 cast freestanding woodstove 24 operating instructions ash disposal during constant use, ashes should be removed every few days. The ash drawer features a convenient ash drawer for easy removal of ashes. Safety precautions 1) do not allow ashes to build up to the loading doors! Only r...

  • Page 25: Maintenance

    Hampton h200 cast freestanding woodstove 25 maintenance glass installation/ replacement 1) remove door from unit. 2) to replace the glass remove the 12 screws highlighted in the diagram below. 3) lift off the glass retainer and carefully re- move glass. 4) place new glass in the door, make sure that...

  • Page 26: Maintenance

    26 hampton h200 cast freestanding woodstove maintenance if position of bracketry needs to be changed after adjustment: the bracketry should start from the highest point, as seen below. If needed, bring the bracketry down 1/16" each time, until fi nding the best locking position. The door latch will ...

  • Page 27: Maintenance

    Hampton h200 cast freestanding woodstove 27 maintenance top baffle replacement 1) lift the top hob off the top of the stove. 2) remove the fi ve (7/16) socket 1/4 x 1" hex bolts from the firebox top assembly and lift off. Top hob 3) remove the left and right baf fl e caps by removing the 2 bolts (7/...

  • Page 28: Maintenance

    28 hampton h200 cast freestanding woodstove maintenance annual maintenance completely clean out entire unit annually inspect air tubes, baffl es and bricks replace any damaged parts. Adjust door catch / latch if unable to obtain a tight seal on the door - replace door gasket seal. Readjust latch aft...

  • Page 29: Parts List

    Hampton h200 cast freestanding woodstove 29 parts list h200 main assembly part # description 1) 200-301 top charcoal grey 200-305 top timberline brown 2) 200-522 firebox top assembly 3) 200-514 baffle assembly 4) 200-203 baffle cap left 5) 200-204 baffle cap right 6) 200-140 lh baffle retention 7) 2...

  • Page 30: Parts List

    30 hampton h200 cast freestanding woodstove parts list 2 2 2 22 2 2 2 2 2 2 2 0 2 0 20

  • Page 31: Parts List

    Hampton h200 cast freestanding woodstove 31 h200 door assembly parts list part# description 2 0 2 200 2 f 2 200 2 f 2 200 220f 2 0 mm c 2 2 2 h 200 ch c 200 w 220 h 220 0 ch 0 220 0 c h 2 0 0 f w h 0 2 c w h 0 20 2 h h h c ch h.

  • Page 32: Parts List

    32 hampton h200 cast freestanding woodstove parts list h200 ash drawer assembly part# description 200 h w c 2 0 h 2 2 2 200 2 2 h w h 200 2 h w f 20 2 h h 2.

  • Page 33: Notes

    Hampton h200 cast freestanding woodstove 33 notes parts list red --- low white --- common connection diagram black --- high 115v. 60hz. 1.1a j250-150-o44003 t.P. 3000 rpm jakel inc. Date t.P.L b 200 f c 220 02 f h f 2 220 022 f h 220 0 200 22 f c h h 200 22 f c f h 200 22 f h c 0 f 0 2 h c 2 part# d...

  • Page 34: Notes

    34 hampton h200 cast freestanding woodstove notes.

  • Page 35: Warranty

    Hampton h200 cast freestanding woodstove 35 warranty hampton fireplace products are designed with reliability and simplicity in mind. In addition, our internal quality assurance team carefully inspects each unit thoroughly before it leaves our facility. Fpi fireplace products international ltd. Is p...

  • Page 36: Register Your Regency

    Installer: please complete the following information dealer name & address: ______________________________________________ ___________________________________________________________________ installer: ___________________________________________________________ phone #: _____________________________...