Fracino Bambino Installation Instructions Manual - Preparing For
Preparing for
Installation
Services and
equipment
required for
installation
A
4
All machines require a mains water & power supply as specified below. It is highly
recommended that a mains waste outlet is provided but a bucket is sufficient if not
available. All services must be in place prior to installation.
ALL CALLS TO UNPREPARED
SITES ARE FULLY CHARGEABLE.
Mains water:
15mm mains cold water supply with ¾'' BSP standard washing machine stop cock.
Note:
Min inlet water pressure : 100kPa (1 Bar)
Max inlet water pressure : 600kPa (6 Bar)
If water pressure in excess of 600kPa (6 Bar) a Pressure Reducing Valve must be fitted.
Mains waste:
1 ½'' (minimum diameter) stand pipe for flexi hose.
Water and waste connections to be directly beneath the location of the machine
Power supply:
As below
Note:
Socket to be located on the same side of the coffee machine that the grinder will
stand. (Recommended right hand side - see installation overview).
Grinders - All models 13amp
Coffee Machines - Standard Power Ratings
Coffee Machines - Alternative Power Ratings
Note:
Alternative power ratings must be specified on order if required.
1 Group
2.7kw
13amp
2 Group*
4.0kw
20amp single phase
3 Group
7.5kw 32amp single phase
4 Group
7.5kw 32amp single phase
* Except Bambino which is 2.85KW / 13amp. 4kw available as an
alternative power rating on 20amp single phase supply
Group
kw
amp
Group
kw
amp
2 Group
2.85kw
13amp
2 Group*
4.0kw
20amp single phase
2 Group
7.5kw 32amp single phase
3 Group
9.0kw 45amp single or three phase
4 Group
9.0kw 45amp single or three phase
* Bambino model only