Francotyp-Postalia FlexiScale Operation manual - page 8
8
3.3.2
NUMERIC KEYS
The numeric keys (0-9) are used when numeric data needs to be
entered into the system. The ENTER key is used to enter the dis-
played data while the C/CE key is used to clear the current nu-
meric entry. The C/CE key also returns you to the previous screen.
3.3.3
OPERATOR KEYS
The four keys shown in the diagram below are located below the
display and perform a variety of operator functions related to rate
calculations as well as actual scale operation. In each case, press-
ing the key will activate the chosen function, or display multiple
selections.
Courier Key. The "COURIER" key is used to select one of the available
carriers (e.g. U.S.P.S., FedEx or U.P.S.) to use for rate calculation.
Options Key. The "OPTIONS" key allows access to the scale’s extra fea-
tures including piece counting, service menus and system setup.
Refer to Section 6 for the system setup procedures.
Label Key. The "LABEL" key is used to print either single or multiple post-
age tapes. If a U.S.P.S. postage value appears in the display, press-
ing the "LABEL" key once will send the charges to the meter, gen-
erating a postage tape. Pressing and holding the "LABEL" key for
three seconds activates the function to generate a quantity of la-
bels on the postage meter. Refer to Section 5.1 for the multiple
labels procedure.
Zero Key. The "ZERO" key is used to zero or tare the scale. When the
scale is in the weighing mode with nothing on the weighing platter
and this key is selected, the scale zeroes the weight. If a con-
tainer is on the scale and the key is selected, the weight of the
container is tared.