Frantz 135F-1/4HP Owner's Manual - Warning
WARNING
To prevent electrocution or fire,
installation and wiring must be in
compliance with local electrical and
building codes .
Activate opener with any of the following
devices:
1. The Remote Control: Hold the push button
down until the door starts to move.
2. The Door Control: Hold push bar or button
down until the door starts to move.
3. The Outside Keylock or Keyless Entry
System.
When the Opener is Activated:
1. If open, door will close. If closed, the door will
open.
2. If closing, the door will reverse.
3. If opening, the door will stop (allowing space for
entry and exit of pets and for fresh air).
4. If the door has been stopped in a partially open
position, it will close.
5. If obstructed while closing, the door will reverse.
6. If obstructed while opening, the door will stop.
With the safety reversing sensor installed and
correctly aligned, the door will reverse in the closing
cycle when the invisible beam is broken. If fully
open, the door will not close when the beam is
broken. Sensor has no effect in the opening cycle.
Operation of your Opener
If the sensor is not installed or not aligned correctly,
you can’t close the door from any remote control
transmitter. You can close the door with the door
control, however, if you press and hold the push bar
or button until down travel is complete. If you
release the push bar or button too soon, the door will
reverse. The opener light will blink for 5 seconds
when the safety reversing sensor is obstructed.
The Opener Light will turn on under the following
conditions: When the opener is initially plugged in;
when the power is interrupted; when the opener is
activated. It will turn off automatically after 4-1/2
minutes or provide constant light when the Light
feature is activated. Bulb size is 75 watts maximum.
The Door Control Push Bar
Press to open or close the door. Press
again to reverse the door during the
closing cycle to stop the door while it’s
opening.
Light Feature: Press the Light button. If
the opener light is off, it will turn on.
If the opener light is on, (even in the 4-1/2
minute automatic cycle) it will turn off.
But if you use the Light button to turn the
light on and then activate the opener, the
light will turn off after 4-1/2 minutes.
The Light Feature will not turn the opener
light off when the door is in motion.
Lock Feature: Designed to prevent
operation of the door from portable remote
controls. However, the door will open and
close from the Door Control push bar and
from the Keylock and the Keyless Entry
Accessories.
To activate: Press and hold the Lock button
for 2 seconds. The push bar indicator light
will flash as long as the Lock is on.
To turn off: Press and hold the Lock button
again for 2 seconds. The indicator light will
stop flashing. Normal operation will resume.
The Lock feature will also turn off whenever
the “Smart” button on the opener end panel is
activated.
Operation of the Multi-Function Door Control Panel
To open the door
manually:
The door should be fully
closed if possible. Pull
down sharply on the red
manual release handle
and lift the door
manually. To reconnect
the door to the opener,
press the Door Control
push bar or button.
32
Operation of the Lighted Door Control Button
Press to open or close the door.
Press again to reverse the door during the closing cycle or to stop the door while it’s opening.
The lockout feature
prevents the trolley from
reconnecting automatically.
Pull the manual release
handle down and back
(toward the opener). The
door can then be raised
and lowered manually as
often as necessary. To
disengage lockout feature,
pull the manual release
handle straight down. The
trolley will reconnect on the
next up or down operation.