As-1r/ambi space digital reverb owner’s manual ver 1.0
2 3 table of contents controls and indicators 3 front panel 3 rear panel 4 5 adjusting reverb (manual mode) 6 switching four presets 6 confirming the position of each knob stored in the preset 6 when the unit is put in edit mode from preset mode 7 changing midi reception settings 7 setting midi rece...
4 5 controls and indicators rear panel side panel bottom panel this terminal is used to connect the dedicated ac adapter supplied with the as-1r. An ac adapter with regulated 9 vdc output, center minus polarity, and power supply capacity of higher than 280 ma, such as the free the tone fa-9, can als...
6 7 adjusting reverb (manual mode) changing/writing preset contents (edit mode) configuring midi signal reception settings switching presets (preset mode) adjusting reverb sound when the unit is put in edit mode from manual mode when the unit is put in edit mode from preset mode changing midi recept...
: led on, : led off. 8 9 preset 1 001 preset 2 002 preset 3 003 preset 4 004 preset number program change number pre delay 92 0–127 decay 93 0–127 tone 94 0–127 mix 95 0–127 mode 96 1–6 effect on/off 65 off = 0, on = 127 controls midi cc numbers value range preset 1 led midi channel to be set preset...
10 11 preset-1 spring mode preset-2 plate mode preset-3 hall mode preset-4 serene mode safety precautions precautions are identified by the two types of symbols below: warning caution be sure to read these precautions and the user's manual before using this product. Warning caution support / service...
