G-Lab DR-2 User Manual - page 7

5

Control settings

The REVERB 1 or 2 switch enables to select sound characteristics of the used reverb.

TIME controls enable adjusting the reverb time from hundreds of milliseconds up to few

seconds (REVERB 2 offers longer lasting sounding). LEVEL controls enable adjusting the

proportion of the resounded from zero signal to the level of 25% of the incoming one.

Thanks ability of setting two pairs of reverbs time and level parameters, and also thanks

footswitching between these two pairs (REVERB A and B) it is possible switching the used

reverb while playing, what reasonably increases a guitar tone performances.

Typical controls settings:

- quick support playing:  REVERB = 2, TIME = 1 to 2, LEVEL = 3 to 5,

- slow support playing:  REVERB = 2, TIME = 2 to 4, LEVEL = 4,

- solo:  REVERB = 2, TIME = 3 to 5, LEVEL = 4 to 6.

Power supply

The DR should be supplied from external regulated 9V DC power supply, with 80 mA

output or more. Before connecting please check if the connector’s polarisation is proper.

REMARK: Damage of the DR caused by supplying it with power of improper

          voltage effects in loss of the warranty.