Summary of ARCH 90 90X3W
Page 1
1.
Page 2: 1. General Information
1. General information introduction:congratulations, you have just purchased one of the most innovative and reliable led fixtures on the market today. Our company has been designed to perform reliably for years when the guidelines in this booklet are followed. Please read and understand the instruct...
Page 3: 2. Safety Instructions
2. Safety instructions ● 1. In order to ensure the light could operate normally, the ambient temperature couldn't be higher than 35 ° c and no lower than 2 ° c. Notice: to guarantee proper and consistent operation, it is important to follow the guidelines in this manual. Our company will not accept ...
Page 4
4 3. Performance trait and skill specifications ◎ lighting equipment is installed with 90pcs led, lighting equipment use the led illuminant with high performance and super luminance. ◎ voltage: 200v-240v/50hz (90v-260v is selective) ◎ led qty:12r+12g+18b+18w+30a ◎ led power: 3w ◎ power: 280w ◎ size：...
Page 5: 4. Operation Panel
4. Operation panel 5. Dimensional drawings 5.
Page 6: 6. Photometric Data
6. Photometric data 6.
Page 7: Cautions:
7. Mounting and installation cautions: for added protection mount the fixtures in areas outside walking paths, seating areas, and away from areas were unauthorized personnel might reach the fixture. Before mounting the fixture to any surface, make sure that the installation area can hold a minimum p...
Page 8: 1. Power Supply
8. Power supply and signal connection 1. Power supply use the professional plug to connect the projector and main power supply. Please pay attention to the voltage, frequency the same as the mentioned on the projector. Suggest each light has separately switched of the power supply so that could turn...
Page 9: 3. Light Power Connection:
Recommend to use the dmx signal terminator for the installation to avoid the electronic noise damage the digital control signal. Simply speaking, dmx terminator is an xlr connector with a 120Ω/1w resistor connected across pin 2 and 3.Which is then plugged into the output socket on the last projector...
Page 10: 9. Display Menu
9. Display menu note: 1. Power, the bottom right corner of the display window small dots lit, indicating that the lighting equipment is switched on. 2. Power, the display window flashes the bottom right corner of the small dots, indicating that the lamp is switched on dmx512 signal control status is...
Page 11: 10. Dmx Traits
11 10. Dmx traits channel model channel order function dmx values and effect 6 1 red 0，no light；1-255, b y dark to 100% light 2 green 0，no light；1-255, b y dark to 100% light 3 blue 0，no light；1-255, b y dark to 100% light 4 white 0，no light；1-255, b y dark to 100% light 5 amber 0，no light；1-255, b ...
Page 12
12 channel model channel order function dmx values and effect 8 1 red 0，no light；1-255, b y dark to 100% light 2 green 0，no light；1-255, b y dark to 100% light 3 blue 0，no light；1-255, b y dark to 100% light 4 white 0，no light；1-255, b y dark to 100% light 5 amber 0，no light；1-255, b y dark to 100% ...
Page 13
11. Circuit connecting diagram 13.
Page 14: 12. Explode Diagram and List
12. Explode diagram and list 14.
Page 15
15 no. Inquire number no. Inquire number 1 m0400150 14 m01019108 2 m0600825 15 z0600742 3 m0300772 16 m0600930 4 m0101994 17 m0101978 5 m0202175 18 m0300774 6 m0400149 19 m0300773 7 m0101975 20 m1000908 8 m0101976 21 m01019106 9 z0600176 22 m1300768 10 m0400151 23 z0600325 11 m1300767 24 m0300768 12...
Page 16: 13. Trouble Dispose
16 13. Trouble dispose it is recommended some solution for some normal trouble shooting. Any inextricability problems should always be handling by the professional person. Disconnect the power supply before maintenance the light. ● led off： 1. Please check if install the suitable voltage 2. Please c...
Page 17
3. Please check the light if they are deformation, inside parts is broken, become wet etc will lead the loose contact. 14. Cleaning and maintenance ■ 1. In order to ensure the projector could work normally. It should be kept clean always .The lens should also be regularly cleaned to maintain an opti...