G-lites Moon Light User Manual - page 11
Moon Lite User Manual
10
8
. POWER SUPPLY AND SIGNAL CONNECTION
1. Power supply
Use the professional plug to connect the projector and main power
supply. Please pay attention to the voltage, frequency the same as the
mentioned on the projector. Suggest each light has separately switched of
the power supply so that could turn on or turn off each projector
desultorily.
2. Signal connection
Please use the round 3-pin or 5-pin XLR plugs &sockets offered
by menu facture to connect the first projector's output to the second
projector' input and connect the second projector's output to the third
projector's input. And in the same way for the rest, eventually connect the
last projector's output, all the projectors are together as the following
figure.
The projectors’ control signal output or input by using the 3-pin or 5- pin
XLR pug and socket. If need to long then the communication cable,
please make sure the both side of 3-pin or 5-pin plug is one to one. (one
to one, two to two, three to three). Otherwise, the communication cable
will be interrupted. The communicate cable is 2-pin shielded cable 75
Ω