G-project G-BUZZ User Manual - Note:
SETTING THE ALARM
Alarms can be set while G-BUZZ is powered ON or in STANDBY mode.
1 Slide the ALARM 1 or ALARM 2 switch to “SET”. The alarm time will begin to
blink on the display.
2 Setting Alarm Time – Press the << button repeatedly to select the alarm
hour, then press the
>> button repeatedly to select the alarm minute.
Press the “SET” button to confirm alarm time and enter alarm source mode.
3 Setting Alarm Source – There are total six alarm sounds for each alarm
(FM Radio, buzzer and four unique sounds; Rooster, Foghorn, Bells or Jungle).
The default alarm source is FM Radio and uses the current station G-BUZZ
is tuned to. Press the
<< or >> button repeatedly to select a different alarm
source. Press the “SET” button to confirm alarm source.
4 Setting Alarm Volume – After confirming the alarm source, the display will
show the default alarm volume level. Press
+ or – button repeatedly to
adjust and select the desired alarm volume.
5 Saving Alarm Setting – Slide the ALARM 1 or ALARM 2 switch to “ON” to
save these alarm settings. The LED alarm indicator will appear on the display.
NOTE:
FM station can not be selected in alarm source mode and must be tuned
prior to setting an alarm.