1. DL manuals
  2. G&V Global Tech
  3. GPS
  4. i-Blue 747
  5. User Manual

G&V Global Tech i-Blue 747 User Manual

Manual is about: iBT-GPS Bluetooth GPS Data Logger

Summary of i-Blue 747

  • Page 1

    Ibt-gps bluetooth gps data logger user’s manual published on 01-feb-2008 8029407701f.

  • Page 2

    2 table of contents chapter 1 before you begin.........................................................................................4 1.1 note and warning ..........................................................................................4 1.2 introduction.....................................

  • Page 3

    3 appendix c. Certification .................................................................................24 appendix d. Warranty information ................................................................26.

  • Page 4: Chapter 1 Before You Begin

    4 chapter 1 before you begin 1.1 note and warning - ibt-gps uses lithium battery. If ibt-gps is used in temperature lower than -10℃ or higher than 60℃, its battery charging capability will decrease. Please leave the ibt-gps far from heat or high temperature environment. In addition, do not expose yo...

  • Page 5: 1.2 Introduction

    5 - use a dry, clean soft cloth to clean the unit. Do not use harsh cleaning solvents, chemicals, or strong detergents. - do not attempt to open the ibt-gps yourself. Unauthorized hacking may damage the unit, and void your warranty. 1.2 introduction this ibt-gps logger features an all-in-one, cost-e...

  • Page 6: 1.4 Applications

    6 10. Fully compliant with bluetooth v1.2 11. Support nmea compliant mapping software like tomtom, route66…etc. 1.4 applications - route recording - business trip expense management - fleet management - driving behavior monitoring - saving of point of interest.

  • Page 7: 1.5 Appearance

    7 1.5 appearance 1. Dc jack (mini usb type) 2. Mode switch (power off/ navigation/ navigation&log) 3. Bluetooth status led (blue) 4. Battery status led (red/green) 5. Gps status led (orange) / push to log led (blue) 6. Internal gps antenna 7. Push button.

  • Page 8

    8 1.6 power switch and push button power switch right (off) power off middle (nav) enable navigation mode left (log) enable navigation + log mode push button push push to log points of interest, led blinks 3 times. Difference between nav and log: nav you can use the ibt-gps as a bluetooth gps receiv...

  • Page 9: 1.7 Led Display

    9 1.7 led display the bluetooth gps data logger has three led lights, one is bluetooth status led, the 2 nd one is battery status led, the 3 rd one is gps status led/ push to log led. The status table of led shows as follows: category symbol color status function always on: bluetooth on, but not con...

  • Page 10: Chapter 2 Getting Started

    10 chapter 2 getting started 2.1 checking the package content congratulations on your purchase of the ibt-gps with built-in lithium rechargeable battery. Before you start using ibt-gps, please make sure if your package includes the following items. If any item is damaged or missing, please contact y...

  • Page 11: 2.2 Getting Started

    11 2.2 getting started please follow the procedure step by step. Step 1 charging your battery to charge your ibt-gps data logger, you have to plug your usb cable into the power source. Charging time is about 3~4 hours and you can charge from pc/ notebook’s usb host or from cigarette-lighter in car. ...

  • Page 12

    12 step 2 turning on the power switch (nav/ log) power off navigation data record difference between nav and log: nav you can use the ibt-gps as a bluetooth gps receiver to navigate when you have a bluetooth enabled pda/ smartphone in your car. The logging is off. Log in this mode ibt-gps works as a...

  • Page 13: Connection.

    13 below, we provide a common procedure of software installation to set up your pda. (for other pda, the steps may be different. Bluetooth manager is a popular program used on bluetooth device.) --> start -> bluetooth manager new 1. Open “bluetooth manager” on your pocket pc, and establish a new con...

  • Page 14: 3. (Optional)

    14 --> explore a bluetooth device ->next tap ibt-gps 2. Explore a bluetooth device, and find the “ibt-gps” passkey 0000 (if your pda asks for the passkey) 3. (optional).

  • Page 15

    15 --> select spp slave->next finish 4. Connect to serial port profile (spp) slave --> tap and hold ibt-gps: spp slave, connect done 5. Finish bluetooth manager setup.

  • Page 16

    16 step 4 loading your gps mapping or routing software you should have mapping software on your pda/ smartphone/ laptop or you need to install it before using the ibt-gps for navigation. Step 5 starting the application select the correct com port & baud rate within the application note: the bluetoot...

  • Page 17: 2.3 Helpful Tips

    17 2.3 helpful tips - it’s better to turn off the ibt-gps when you don’t use it, or the serial flash's life can’t last long. - some vehicles having heavy metallic sun protecting coating on windshields may affect gps signal receptions - driving in and around high buildings may affect gps signal recep...

  • Page 18: 3.2 Google Earth

    18 chapter 3 using photo tagger software 3.1 execute and install software utility photo tagger complete gps photo tagger and usb drivers installation (refer to cd) 3.2 google earth if you computer is not yet installed with google earth. Google earth has free download version, go download it in the i...

  • Page 19

    19 3.3 software utility --- ibt-gps photo tagger for further function to use the photo tagger software in detail, please refer to photo tagger user manual: photo tagger software > help > user manual to use a mini-usb cable to connect the ibt-gps to your pc, you have to power on the ibt-gps unit. Ple...

  • Page 20: Appendix

    20 appendix appendix a. Specifications general frequency l1,1575.42mhz c/a code 1.023mhz datum wgs84 performance characteristics position accuracy without aid: 3.0m 2d-rms dgps (waas,egnos,msas):2.5m velocity accuracy without aid: 0.1m/s dgps (waas,egnos,msas):0.05m/s acceleration without aid: dgps ...

  • Page 21

    21 dynamic altitude maximum 18,000m velocity maximum 515m/s acceleration maximum 4g power input voltage vin : 5.0v±5% power consumption 40ma battery built-in rechargeable 1000mah lithium battery i/o available baud rates 115200 bps protocols nmea 0183 v3.01 environment operating temperature -10 ~ 60c...

  • Page 22

    22 usb bridge standard fully compliant with usb2.0 full - speed 12mbps dimension 46.5 x72.2 x20 mm data log 32mb serial flash rom up to 150,000 way points. Log gps data by time interval/ distance/ speed limit. Log gps data by button push. User can configure settings by using utility..

  • Page 23: Appendix B. Locr Gps Photo

    23 appendix b. Locr gps photo with ibt-gps data logger and locr gps photo software, users are allowed to import geotagging adds information to photos. The position (latitude/ longitude) then be written into the exif header for the further application. Also, locr gps photo can integrated travel log a...

  • Page 24: Appendix C. Certification

    24 appendix c. Certification fcc notices this device complies with part 15 of the fcc rules. Operation is subject to the following two conditions: 1. This device may not cause harmful interface, and 2. This device must accept any interference received, including interference that may cause undesired...

  • Page 25: Ce Notices

    25 ce notices is herewith confirmed to comply with the requirements set out in the council directive on the approximation of the laws of the member states relating to electromagnetic compatibility (89/336/eec), low-voltage directive (73/23/eec) and the amendment directive (93/68/eec), the procedures...

  • Page 26

    26 appendix d. Warranty information thank you for your purchase of gps product from the company. The company warrants this product to be free from defects in materials and workmanship for one year from the date of purchase. The warranty for accessories is six months. The stamp of distributor or a co...