Summary of AT 400
Page 1
Table ventilation at 400 gaggenau operating instructions.
Page 3
Safety notes 4 operating for the first time 5 maintenance 5 features of your new appliance 6 accessories 7 special accessories 7 accessories for installation 7 operating principle 8 operation 9 ventilation 9 intensive mode 9 light 9 special functions 10 setting the intensive mode duration 10 delayed...
Page 4
Do not operate a damaged appliance. Carefully read through the operating instructions before operating the table ventilation. Keep the operating instructions for further reference. The table ventilation is intended solely for household use and must not be put to any other uses. Do not extract hazard...
Page 5
몇 risk of poisoning if the extractor hood is operated at the same time as a heating appliance which is dependent on ambient air, there is a risk of poisoning due to combustion gases being drawn back in. • safe operation is possible provided the low pressure in the installation room of the heating ap...
Page 6
Combination of at 400-101 with gaggenau hob ce 490 /ci 490 features of your new appliance 6 combination of at 400-131 with three gaggenau vario 400 series appliances control panel cover light air inlet control panel grease filter saturation display light delay shut off intensive mode ventilation lev...
Page 7
Special accessories please order the following special accessories for air recirculation mode: • aa 409-100: activated carbon filter and grease fine filter for at 400-100 • aa 409-130: activated carbon filter and grease fine filter for at 400-130 you can order the following special accessories for a...
Page 8
The table ventilation is an effective air recirculation system, which extracts the vapours directly behind the cooktop towards the rear. The centrifugal grease filters separate the greasy components from the extracted air. The grease is collected in the trays. The grease fine filter absorbs any rema...
Page 9
When pressed, all functions selection keys are backlit in green, except 0 (“motor off”). Ventilation three fan speeds and one intensive speed are available. You set the fan speed required for each respective cooking process by pressing the function selector keys 1, 2, 3 or int. Intensive mode the in...
Page 10
Setting the intensive mode duration you can select an intensive level running time of 3, 5 or 10 minutes by simultaneously pressing the int key and the 1, 2 or 3 key. When delivered, the appliance is set to five minutes, i.E. The combination of the int key and the key 2. Delayed shut-off delayed shu...
Page 11
Cleaning and care 11 cleaning the housing clean the stainless steel surface of the ventilator housing with mild detergent solution or a non- scouring stainless steel cleaner. Only wipe in the the direction of the brushed surface. To finish, apply some stainless steel care agent with a soft cloth. Do...
Page 12
12 cleaning the grease filters the grease filter saturation display f flashes after an operating time of 10 hours to indicate that you should clean the grease filters. Depending on the cooking habits it may be necessary to clean the grease filters at shorter intervals (for example if kitchen smells ...
Page 13
13 replacing the activated carbon filter (only for air recirculation mode) the activated carbon filter in the fan housing (lower part of the appliance) eliminates smells from the extracted air. For hygenic reasons, change the activated carbon filter together with the grease fine filter at least ever...
Page 14
Wait until the appliance has cooled down before replacing lamp. 1 disconnect the appliance from the mains (switch off fuse). 2 remove loose objects from the cover. 3 lift off cover. 4 first turn florescent lamp in the socket, then lift off fluorescent lamp. 5 only replace defective fluorescent lamp ...
Page 16
Gaggenau hausgeräte gmbh carl-wery-straße 34 d-81739 münchen www.Gaggenau.Com 9000137543 eb 8910 en.