Gaggenau BS 450 Instruction Manual - page 29
29
A signal sounds after 1 minute. Empty the evaporator
dish with the cleaning sponge. Empty the water tank
and leave it to dry with the lid open. Wipe the cooking
compartment dry with a soft towel and use the drying
programme to dry completely.
Notes
‒
The cleaning aid must always be run through
completely and cannot be cancelled.
‒
Before cooking, remove any cleaning agent
residue from the cooking compartment.
‒
If the cleaning aid was cancelled due to a power
cut, it must be restarted before using the oven
again in order to remove any cleaning agent
residues from the appliance.
Drying programme
With the drying program, you can dry the cooking
compartment after cleaning or after steaming.
The drying program takes 20 minutes.
Caution! Do not dry the water tank in the hot oven
interior. This would damage the water tank.
Starting the drying program
1
Remove the water tank. Remove accessories from
the cooking compartment. Empty the evaporator
dish with the cleaning sponge. Wipe out the
cooking compartment. Thoroughly remove
residues of cleaner. Close the appliance door.
2
Set the function selector to S. Select the drying
program with the rotary selector.
3
The
j
symbol is displayed. Touch
™
to confirm.
4
The drying time of 20 minutes appears. Touch
I
to
start. The drying time elapses on the display. The
lamp in the cooking compartment stays off.
5
A signal sounds after 20 minutes. A message
appears in the display. Touch
™
to confirm.
The drying programme has ended. Allow the appliance
to cool down. Then polish the cooking compartment
and the panel with a soft cloth.
Descaling programme
Your appliance must be descaled at regular intervals
for it to remain operable. A reminder appears in the
display.
The descaling programme consists of the steps of
descaling and twice rinsing.
Descaler
For descaling, use only the liquid descaler
recommended by after-sales service (order No.
311138 from after-sales service or in the online shop).
Other descaling agents can cause damage to the
appliance.
Caution! Surface damage: Wipe off descaler
immediately with water if it reaches the door seal, the
front or other sensitive surfaces.
Start the descaling programme
The cooking compartment must have cooled down
completely.
1
Prepare a descaling solution by mixing 300 ml
water and 60 ml liquid descaler.
2
Set the function selector to S. Use the rotary
selector to select the descaling programme.
3
The
‘
symbol is displayed. Confirm with
™
.
4
Fill the water tank with the descaling solution and
slide it into the tank compartment. Close the
appliance door. Confirm with
™
.
5
The descaling time of 30 minutes is displayed.
Start with
I
. The descaling time counts down on
the display. The light in the cooking compartment
remains switched off.
6
A signal sounds after 30 minutes. A message
appears on the display.
7
Empty the evaporator dish with the cleaning
sponge. Fill the water tank with cold water.
Confirm with
™
.
'U\LQJSURJUDPPH
_
'HVFDOLQJSURFHVV
_