Gaggenau DF 250 Operating Instructions Manual - page 32
32
Installation and connection
Warm water connection *
Warm water connection
* depending on model
The dishwasher can be connected to cold or hot water
up to max. 60 °C.
Connection to hot water is recommended if the hot
water can be supplied by energetically favourable
means and from a suitable installation, e.g. solar
heating system with circulation line.
This will save energy and time.
The hot water setting ‘:‹‚ allows you to adjust your
appliance optimally to operation with hot water.
It is recommended to have a water temperature
(temperature of the incoming water) of at least 40 °C
and no more than 60 °C.
It is not recommended to connect the appliance to hot
water if the water is supplied from an electric boiler.
Setting hot water :
1
Open the door.
2
Switch on ON/OFF switch (.
3
Hold down programme button # and press
START button )" until •:‹... is indicated on the
digital display.
4
Release both buttons.
The LED for button # flashes and the digital
display 8 displays the factor y setting •:‹….
5
Press programme button # until the factor y set
value ‘:‹‹ is indicated on the digital
display 8.
To change the setting:
1
By pressing the 3 button, you can switch the
hot water setting off ‘:‹‹ or on ‘:‹‚.
2
Press START button )".
The set value is saved.
3
Close the door.
Electrical connection
Connect the appliance to an alternating current
only, ranging from 220 V to 240 V and 50
Hz or 60 Hz via a correctly installed socket with
protective earth conductor. See rating plate
for required fusing 9:.
The socket must be near the appliance and freely
accessible following installation.
If the plug is not freely accessible, an allpole
disconnector with a contact opening of at least 3
mm must be fitted on the installation side
to satisfy the relevant safety instructions.
The connection may be modified by technicians
only.
A power cord extension may be purchased from
customer ser vice only.
Use only a residual current operated circuit-
breaker which features the symbol ‚. Only this
extension guarantees compliance with
the currently valid regulations.
The appliance features a water damage
protection system. Please note the system will not
function unless the power supply is connected.