Gaggenau DF460 Operating Instructions Manual - page 21
21
Waste water pump
Large food remnants in the rinsing water not retained
by the filters may block the waste water pump. The
rinsing water is then not pumped out and covers the
filter.
In this case:
1
First disconnect the appliance from the power
supply.
2
Remove the filters 1j.
3
Scoop out water, use a sponge if required.
4
Using a spoon, prise off pump cover (as
illustrated) until it clicks, then grip the cover by
the lug and first pull it upwards until it resists and
then pull it out forwards.
5
Check inner compartment and remove any foreign
objects.
6
Place cover in the original position, press down
and engage.
7
Install filters.
... when the appliance is
switched on
The appliance does not start.
The mains fuse has tripped.
The appliance plug has not been inserted.
The appliance door has not been shut properly.
... changing settings
A setting cannot be changed, a programme
starts.
Wrong programme button pressed. Terminate the
programme (see chapter entitled “Terminating the
programme (Reset)”) and start all over again.
You did not wait until programme ended.
... on the appliance
Lower spray arm rotates sluggishly.
Spray arm blocked.
The door is difficult to open. *
Child-proof lock is activated. The deactivation
instructions are at the back in the envelope.
* depending on model
Door cannot be closed.
Door lock has been activated. To reset, close the
door with greater force.
Cover on the detergent dispenser cannot be
closed.
Detergent dispenser overfilled or mechanism
blocked by sticky detergent residue.
Detergent residue in the detergent dispenser.
Dispenser was damp when filled.
“Check water supply” display @ lights up.
Tap turned off.
Water supply interrupted.
Supply hose kinked.
Filter in the water supply blocked.
1
Switch off the appliance and pull out
the mains plug.
2
Turn off the tap.
3
Clean filter in the supply hose.
4
Reconnect power supply.
5
Turn on the tap.
6
Switch on the appliance.
.OLFN