1. DL manuals
  2. Gaggenau
  3. Oven
  4. VG 411 CA
  5. Operation, Maintenance And Installation Manual

Gaggenau VG 411 CA Operation, Maintenance And Installation Manual

Manual is about: Gas Cooker

Summary of VG 411 CA

  • Page 1

    Operation, maintenance and installation manual vg 411 ca gas cooker.

  • Page 3

    1 vg 411 ca for your safety page 2 1. Important information for installation and use page 3 2. General safety instructions page 4-5 3. Important notes page 6-7 for your safety page 6 operating for the first time page 6 about use page 7 4. Features page 8 features of the appliance page 8 control knob...

  • Page 4

    For your safety 2 warning: if the information in this manual is not followed exactly, a fire or explosion may result causing property damage, personal injury or death. Do not store or use gasoline or other flammable vapors and liquids in the vicinity of this or any other appliance. What to do if you...

  • Page 5

    1. Do not allow the flame to extend beyond the edge of the cooking utensil. This instruction is based on safety considerations. 2. Do not forget that the unit becomes hot when in use. Common sense is important. Just because the flame is out, it does not mean parts still cannot be hot. 3. This applia...

  • Page 6

    Read all instructions in this operation and maintenance manual carefully before using your new gaggenau cooktop. As the user, you are responsible for maintenance and proper use in the household. Warning: these precautions will reduce the risk of burns, electric shock, fire, and injury to persons. Us...

  • Page 7

    • never leave the cooktop unattended. Boil-overs cause smoking and greasy spills that may ignite. • only certain types of glass, heatproof glass- ceramic, ceramic, earthenware or other glazed utensils are suitable for cooktop use. This type of utensil may break with sudden temperature changes. Use o...

  • Page 8

    6 for your safety you must not operate the appliance if it is damaged. When connecting electrical appliances in the proxi- mity of the appliance, make sure that connecting leads do not come into contact with hot cooking surfaces! As the user, you yourself are responsible for maintenance and proper u...

  • Page 9

    7 about use the appliance is intended solely for use in the household and must not be put to any other uses. Use the appliance to prepare meals only. It must not be used to heat up the room in which it is installed.! Use of a gas cooker generates heat and humidity in the room where it is installed. ...

  • Page 10

    8 features of the appliance control knob burner parts 1 ventilation openings 2 large (wok) burner 17,000 btu (5 kw) 3 pot grid flame setting: 0 off high setting of outer and inner flame ring low setting of outer flame ring high setting of inner flame ring outer flame ring off high setting of inner f...

  • Page 11

    9 5. Operating principle the appliance features one-hand operation, flame detection and automatic re-ignition. The ignition is activated when the control knob is turned. Should the flame go out during operation, the appliance will automatically re-ignite the burner. During a disturbance, the applian...

  • Page 12

    10 switching on • place a suitable pot or a pan on the cooking position. • press down the control knob and turn it to the required position between the and symbols. The burner ignites automatically. • when using large pots or pans you should ignite the burner in the low position. • every time the ga...

  • Page 13

    11 7. Settings table cooking cooking method examples level high boiling water searing meat heating fat, liquids boiling soup, sauce blanching vegetables roasting meat, fish, potatoes from browning flour, onions roasting almonds, breadcrumbs baking pancakes, egg dishes to boiling in open pot liquids ...

  • Page 14

    Pots with a diameter of less than 160 mm (6 1 / 4 ´ ´ ) or more than 320 mm (12 1 / 2 ´ ´ ) should not be used. When using large pots, pay attention to keeping to a minimum distance of 50 mm (2 ´ ´ ) between the cooking vessel and combustible surroundings. When buying pots, pay attention to the fact...

  • Page 15

    The wok and accessories (not included in the scope of delivery) – the round-bottom wok is the ideal wok for your gas cooker. – the wok looks like a hollow semisphere with a long handle or wooden handle. It has a rounded base and slanted sides. The thin steel passes the heat swiftly to the inside, bu...

  • Page 16

    14 keep the ventilation openings on the rear of the appliance clean. Do not block the ventilation openings. The burner (burner head cover and burner ring) will change the color during operation and become darker. This change in color will not influence the use-value. Please thoroughly clean the appl...

  • Page 17

    15 part / material suggested cleaning procedure important reminders pot grid take pot grids off for cleaning. Do not clean in a dishwasher. (enamel on soak in sink. Soak burnt-in remainders in sink. Cast iron) clean with detergent and brush. Abrasive cleaners, used too vigorously or too often can ev...

  • Page 18

    The appliance must be disconnected from the power and gas supply during all repair work. In the event of malfunctions, check whether the gas and electricity supplies are in proper working order. The cooktop cannot be used during a power failure. If the cooktop is being used when the power failure oc...

  • Page 19

    17 12. Trouble shooting no electrical power switch the appliance on again. Should the appliance still not work, contact your gaggenau after-sales service. Burner does not ignite when switched on overheating protection wait, until the appliance has cooled and the signal goes off turn control knob to ...

  • Page 20

    18 technical data (gas) burners: full burning 17,000 btu (5 kw) low burning 1,000 btu (0.3 kw) gas connection: r 1/2’’ union nut for r 1/2’’ bracket to din 1999, conical-cylindrical technical data (electrical) rated consumption 15 w voltage ac 120 v frequency 60 hz technical modifications reserved. ...

  • Page 21

    19 nozzle, full burn, outer 1.55 110 a nozzle, low burn, outer 0.75 0.56 nozzle, full burn, inner 0.60 0.42 nozzle, low burn, inner 0.48 0.34 air gap adjustm. Outer [mm] 0 0 air gap adjustm. Inner [mm] open, fixed 6 (open) nozzle table wok burner nozzle table countries us ca us ca gas family natural...

  • Page 22

    Important notes please observe the general safety notes and the important information in chapter 1. The installing technician is responsible for perfect functioning of the appliance at its installa- tion location. He must show the user how to switch off the electricity and gas supply whenever requir...

  • Page 23

    Cabinet requirements the minimum spaces that must be maintained when installing the gas cooktop shall be: a minimum 12 ´ ´ (300 mm) b minimum 12 ´ ´ (300 mm) c minimum 30 ´ ´ (762 mm) clearance between the top of the pot stand and the bottom of exhaust hood d minimum 1 9 / 16 ´ ´ (40 mm) 21 c b a d.

  • Page 24

    22 electrical connection electrical connection (ac 110-127 v) is established by means of a connecting cable with a grounding contact plug connected to a grounded socket, which must also be accessible after installation of the gas hob. If, after installation of the gas hob, not all poles can be isola...

  • Page 25

    Gas connection before connecting the appliance, please check whether the local connection conditions such as gas type and gas pressure match the appliance settings. Make sure the gas supply is turned off at the manual shut-off valve before connecting the appliance. The gas connection must be in a lo...

  • Page 26

    Preparing the cabinet • cut out the recess for one or several vario appliances in your worktop. Proceed as indicated on the installation sketch. The installation sketch contains the measurements of the space required for the trim between the appliances. Several appliances can also be installed in in...

  • Page 27

    Installing the cooker please note: if you want to convert the appliance to a different type of gas, change the nozzles before installing the appliance (see pages 28 - 29). • before installation, remove all styrofoam packaging from the control knob and peel off the protective film. • hold the support...

  • Page 28

    26 installing the spindle the numbers correspond to the diagram on the opposite page. Spindle extensions (sv 401-090 / sv 401-205) are available should the appliance be installed in a worktop which is non-standard depth. Loosen the nuts of the spindle cover and remove cover. 1 insert the spindle fro...

  • Page 29

    27.

  • Page 30

    28 nozzle replacement changing over to a different gas type only authorised specialists are permitted to change over to a different gas type. The nozzles needed for the gas type to be set are available as a conversion kit. Please specify the appliance type and the required gas type. The nozzles can ...

  • Page 31

    Replacing the main burner nozzles of the wok-burner • unscrew the wok burner from the trough (torx t20). Loosen locking screw from the air regulation bush. Fully push in the air regulation bush. Detach the safety springs on the supply line. Leave the electrode connected. • carefully pull off the wok...

  • Page 32

    5551 mcfadden avenue huntington beach, ca 92649 usa y (800) 828-9165 · fax (714) 901-0979 www.Gaggenau-usa.Com gaggenau hausgerÄte gmbh carl-wery-str. 34 · 81739 mÜnchen germany y (089) 45 90-03 fax (0 89) 45 90-23 47.