1. DL manuals
  2. Gaggenau
  3. Grill
  4. VR 421-611
  5. Operating And Assembly Instructions Manual

Gaggenau VR 421-611 Operating And Assembly Instructions Manual

Summary of VR 421-611

  • Page 1

    Operating and assembly instructions vr 421-611 electric grill.

  • Page 3

    Vr 421-611 1 important safeguards page 3 1. Important notes page 4-5 for your safety page 4 operating for the first time page 5 about use page 5 2. Features page 6 features page 6 included accessories page 6 special accessories page 6 3. Operation page 7-8 switching on page 7 switching off page 8 re...

  • Page 4

    2 congratulations on purchasing your new “vario” appliance. Before switching your appliance on for the first time, we would like you to familiarize yourself with your new appliance. In this manual you will find important instructions on safety and operation. They will serve to ensure your personal s...

  • Page 5

    1. Read all instructions. 2. To eliminate the risk of burns or fire by reaching over the heated surface units, cabinet storage space located above the surface units should be avoided. 3. Important instructions a) ensure that this appliance is properly connected and grounded by a qualified electricia...

  • Page 6

    4 for your safety do not operate the appliance if it is damaged. The appliance must only be connected by an authorised specialist, paying attention to the relevant regulations of the power supply companies and the regional construction regulations. Observe the assembly instructions! When connecting ...

  • Page 7

    5 operating for the first time remove the packaging from the appliance and dispose of it according to local regulations. Be careful to remove all accessories from the packaging. Keep packaging elements and plastic bags away from children. Check the appliance for transport damage before installing it...

  • Page 8

    6 features included accessories special accessories 1 appliance cover 2 cast grid iron (two parts, detachable) 3 work surface 4 grilling elements 5 lava stone container to accommodate the lava stones 6 grease tray (dishwasher-proof) 7 control knob for front grilling element 8 control knob for rear g...

  • Page 9

    7 note: before switching on, make sure that there are lava stones in the appliance and both grid irons are correctly fitted. Place the grid irons on the grill, so that they cover the heating elements. This guarantees a good transfer of heat onto the grid irons. Fat will drip over the lava stones int...

  • Page 10

    Switching off fully turn both control knobs to the off position. Residual heat display after switching both control knobs to the off position, the luminous discs behind the control knobs will flash, as long as the grill has not cooled down sufficiently to be touched safely. Holiday safeguard (automa...

  • Page 11

    Note: make sure before switching on that there are lava stones in the appliance. The lava stones guarantee an even, intensive transfer of heat. Only operate the grill with lava stones. Remove both grid irons. Place the griddle plate on the grill, so that the feet of the griddle plate lie on the lava...

  • Page 12

    10 the specified grilling times serve as guide values only. 5. Settings table item level* grilling time* remarks meats beef steak 11 to 12 4 - 5 min. Each side turn, when the steak comes off easily from the grid iron. The steak is medium, when juice forms on the top. Veal chop 9 to 11 2 x 3 min. Eac...

  • Page 13

    • the grilled result depends on the nature and quality of the meat and on your personal taste. • if possible, grilled pieces should be equally thick. In this way, they will brown evenly and they will stay nice and juicy. • always preheat the grill. The intensive heat radiation will seal the surface ...

  • Page 14

    Beef tender cuts of beef are particularly suitable. If you have not had much grilling experience, you should practice with pieces of meat such as rump steak or ribs, after which you can try your hand at fillet steak. For smaller pieces of meat, the grid iron must be very hot, otherwise the meat will...

  • Page 15

    Caution, risk of burns! Before cleaning, please wait until the appliance has cooled to hand- warm. Cleaning the grill after every use avoids residues burning in. If residues have burned in several times, they are difficult to remove. Do not use scouring agents, abrasives or chemically aggressive cle...

  • Page 16

    The appliance must be disconnected from the power supply during all repair work. If the appliance does not function correctly, check the fuses first. If the power supply is functioning correctly, but your appliance still does not work, please contact your gaggenau dealer who will provide you with th...

  • Page 17

    Technical data total connected load: 3 000 w ac 208/220-240 v / 60 hz important notes on installation this appliance can be combined with all gaggenau vario 400 series appliances. This appliance may be installed in kitchen combinations made of wood or similar combustible materials without taking add...

  • Page 18

    Preparing the cabinet the building back wall (1) and building side walls (2 / 3) must consist of non combustible material or must be protected by no less than 1 / 4 -inch-thick flame-retardant millboard covered with no less than no. 28 msg sheet steel, 0.015-inch-thick stainless steel, 0.024-inch-th...

  • Page 19

    Preparing the cabinet • cut out the recess for one or several vario appliances in your worktop. Proceed as indicated on the installation sketch. The installation sketch contains the measurements of the space required for the trim between the appliances. Several appliances can also be installed in in...

  • Page 20

    Installing the control panel • before connecting the grill, make sure the electricity is switched off at fuse point! • before installation, remove all styrofoam packaging from the control knobs and peel off the protective film behind the luminous discs. • hold the support plate from the rear against...

  • Page 21

    Installing the grill • firmly plug the connecting cable in the grill and in the control panel (the plugs must lock into place). • turn the clamping screws to the side. Insert the grill with the control panel on the front into the cut-out and align it. Note: do not stick the grill onto the worktop wi...

  • Page 22

    Fitting the appliance cover • the securing brackets are already fitted on the base. • place the appliance cover on the brackets in upright position and screw it down using the pre-mounted grub screws. • close the appliance cover. It must lie evenly on the appliance. • if the cover is not fitted stra...

  • Page 24

    5551 mcfadden avenue huntington beach, ca 92649 usa y (800) 828-9165 · fax (714) 901-0979 www.Gaggenau-usa.Com gaggenau hausgerÄte gmbh carl-wery-str. 34 · 81739 mÜnchen germany y (0 89) 45 90-03 fax (0 89) 45 90 - 23 47.