GAI-Tronics XAC0140A Installation Instructions

Pub.  43003-033A

GAI-Tronics Corporation  P.O. Box 1060, Reading, PA  19607-1060  USA

610-777-1374  

„  800-492-1212  „  Fax:  610-796-5954

V

ISIT WWW

.

GAI

-

TRONICS

.

COM FOR PRODUCT LITERATURE AND MANUALS

G A I - T R O N I C S ®   C O R P O R A T I O N

A   H U B B E L L   C O M P A N Y

Model XAC0140A Navigator Instant Recall

Recorder (IRR) Kit

Field Installation Kit Instructions

Confidentiality Notice

This manual is provided solely as an operational, installation, and maintenance guide and contains

sensitive business and technical information that is confidential and proprietary to GAI-Tronics.

GAI-Tronics retains all intellectual property and other rights in or to the information contained herein,

and such information may only be used in connection with the operation of your GAI-Tronics product or

system.  This manual may not be disclosed in any form, in whole or in part, directly or indirectly, to any

third party.

General Information

The Model XAC0140A Instant Recall Recorder (IRR) Kit for the GAI-Tronics Navigator series consoles

includes the firmware and software necessary to provide instant recall functionality.  This feature

provides the operator the capability to replay the last 20 seconds of received audio at the press of a button.

This kit is intended only for use in the ICP9000 Navigator Series MCU.

It includes the following components:

Qty

Description

1

Pre-programmed Security Key

1

Navigator Software CD

Installation

The ICP9000 Series Navigator and its components are contained on CD-ROM.  Please exit all other

programs that are running until the installation is completed.  To install the ICP9000 Series Navigator to

your PC, perform the following steps:

1.  Place the CD-ROM in the PC’s CD-ROM drive.  If the AutoRun feature on your CD-ROM drive is

enabled, the Navigator Menu screen should appear within a few seconds.  If for any reason the

installation does not start up automatically, it can be run from the start menu.  Select the S

TART

button and then select R

UN

 from the start menu.  At the prompt type: x:\Setup.exe where x

represents the drive letter that is associated with your CD-ROM drive.