Galanz 17010LA User Manual - How To Use Your Kettle
Save this user
’s manual.
How to use your kettle
It is recommended that operate the kettle several times following the below instruction
and discard off the water before first use. This will remove the material or dust remained
in the appliance, which is caused by the manufacturing process.
1. Open the lid and fill water into the kettle. Then replace the lid otherwise the kettle
could not be cut off power automatically after water being boiled.
Caution: The filled water level must be between the
“Max” and “Min” level as indicated
on the housing. Too less water will do damage to the heat element and if the water is
overfilled, boiling water may be ejected.
2. Replace the kettle on the Power Base and connect to power supply. Position the
kettle so that the spout of kettle is facing away from you.
3. Press the switch to
“I” position and the lamp will be illuminated. And water begins to
be heated up. DO NOT open the lid while the water is boiling.
Caution: Ensure that switch is clear of obstructions and the lid is firmly closed,The
kettle will not turn off if the switch is constrained or if the lid is left open.
4. Power will be cut off automatically and Switch will be back to
“0” position once water
has been boiled. And the lamp will be off.
5. Lift the kettle from the power base and then pour the water.
NOTE: operate carefully when pouring the water from your kettle,as boiling water will
scald.
6. The boiling process can be terminated at any time by lifting the kettle off the Power
Base or pressing the Switch to
“0” position.
Caution:
- Never operate the appliance empty. In the event of this case occurred, the
thermal cut-off inside the kettle would operate to cut off power automatically.
Unplug the appliance and let it completely cool down.
- The filter must be in place during operation otherwise water spillage may occur.
NOTE:Ensure the power is turned off while the kettle is not in
use.