Galaxy 1 G1 User Manual - page 7
Rev 1.1
Galaxy 1 Proprietary Information
7
1.4.2 Cisco Router Fronting G1 IG
In default configuration, to configure the G1 IG to operate with a Cisco router fronting the G1 IG Router
the eth3 port must be connected to the Cisco router FE0, FE1, FE2, or FE3 ports. The G1 IG supports
auto MDIX or auto crossover and therefore either a patch or crossover Ethernet cable may be used.
Figure 4: Rear G1 IG
2 Configuration Basics and Initial Setup
The configuration guidance in this document is organized by the outline of the GUI web page. Each
section of the document explains how a page of the GUI behaves and is configured.
Configuration of the G1 IG is performed using an industry standard Internet Browser (Internet Explorer,
Firefox, Chrome, Safari, etc.).
2.1 G1 Intelligent Gateway Initial Setup
The G1 IG supports configuration from an industry standard web browser. In order to access the web
GUI a PC must be connected to the G1 IG LAN interface which by default are either eth0, eth1, or eth2.
The PC should be configured to use DHCP for its address. The default web page GUI is found at
http://192.168.1.1
. The default username is admin and the default password is password123.
2.1.1 Changing the Default Password
When performing initial configuration of the G1 IG it is recommended that the user change the default
admin password.
User and password management is performed under the Advanced tab on the User Management page.
From this page an authenticated user can create new users and reset users passwords. On the G1 IG all
users have administrative privileges.
2.1.2 Setting the System Time
Configuring the G1 IG system clock is necessary prior to utilizing the G1 IG in an operational scenario.
Portions of the G1 IG rely on an accurate time value in order to operate. The user can set the time using
the web interface’s Status Page. On the Status Page the user clicks on the time field and is presented
with a dialog box that allows them to manually set the time or to sync the time to the value of the
workstation which they are using to access the web page configuration interface.