Galaxy 177SMG400 User Manual - page 3
3
Assembly/Disassembly
Using Your New Meat Grinder
1.
Turn the ring on the front of the unit counter clockwise and remove it from the front hub.
2.
Remove the plate from the inside of the hub.
3.
Remove the knife and gear shaft.
4.
Remove the pan from the hub by pulling up on it.
5.
Turn the knob on the side of the motor casing counter clockwise to dislodge it.
6.
Reverse these instructions for assembly. Option 2 you can choose which plate you would
like to use.
1.
Make sure you are using a 120V outlet that will accept a NEMA 5-15P plug.
2.
Remove the meat grinder from the packaging. Inspect the unit and plug for any damage.
DO NOT USE IF DAMAGED.
3.
The meat grinder will come assembled. Disassemble and clean before using. See
cleaning instructions.
4.
After your meat grinder is clean and dry, prepare the meat you will be grinding. Ensure the
meat is cut into small enough pieces that they can be fed into the hopper with minimal
force from the plastic pusher.
5.
Plug the meat grinder in and turn the switch to ON.
6.
Place a bowl underneath the hub to catch all ground meat.
7.
Slowly add meat to the hopper, feeding it through using the plastic pusher. Minimal force
should be used in this process. Pushing down too hard will cause undue stress to the
motor and the potential for damaged parts.