Galaxy Audio Any Spot DHT-QUAD User Manual - page 9

Issue                           Indicator Status                                           Solution

Troubleshooting

Transmitter LCD off. 

    Turn on transmitter.

    Make sure the batteries are installed

    correctly.

Receiver LCD off. 

    Make sure AC adapter is securely

    plugged into electrical outlet and into 

    DC input connector on rear panel of 

    receiver.

Receiver indicates RF.

    Increase receiver volume.

    Make sure Gain adjustment switch on 

    the transmitter is set correctly (applies

    only to MBP76 Bodypack.)

    Receiver indicates No RF,

    Transmitter LCD is on.

    Make sure Transmitter and Receiver 

    are set to the same frequency.

    Make sure Transmitter is in range of

    Receiver.

    Make sure no large metal objects are

    near Transmitter or Receiver.

    The battery power indicator 

     light on LCD flashes.

    Change the batteries in transmitter.

    Distortion or 

    unwanted noise.

    Receiver Indicates RF.

    Remove nearby sources of RF inter-

    ference (CD players, computers,

     in-ear monitor systems, etc.)

    Distortion level 

increases gradually.

    Sound level different 

from cabled guitar or

 microphone, or when 

using different guitars.

    Adjust Transmitter Gain and Receiver 

    Volume as necessary.

   Transmitter power indicator

   light flashing on the LCD.

    Replace Transmitter batteries.

Maintain a line of sight between transmitters and antennas.

Avoid placing the receiver near metal surfaces or any digital equipment (CD players, computers, etc).

Keep the receiver away from the wall and at least 1m from the ground.

Cellular telephones and two-way radios can interfere with the operation of wireless systems.

 Do not use these devices in close proximity to the wireless systems.

Tips for Improving System Performance

    No sound or faint

    sound.