Printed in malaysia at2547010a pd0009028 dx 2547 am/ ssb two way citizen band base station transceiver owner’s manual lsb clarifier clarifier nb am / ssb base station cb radio off dim tone swr mic mic rf phones off rf power pa r. B. Pwr mod dx 2547 rx / tx usb lsb am swr alert anl gnf 40% 1.5 talkba...
- 1 - table of contents page chapter 1 specifications . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2 chapter 2 installation . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3 location . . . . . . . . . . . . . . . . . . . . . ...
Chapter 2 installation location choose a location close to an ac power outlet and convenient for running the antenna lead-in cable. This transceiver is attached with the ac power cord set. Proceed as follows to complete all necessary connections to the transceiver. 1. Your transceiver has a standard...
External speaker the external speaker jack (ext. Sp.) on the rear panel is used for remote receiver monitoring. The external speaker should have 8 ohms impedance and be able to handle at least 4 watts. When the external speaker is plugged in, the internal speaker is disconnected. Phone jack this pho...
6. Swr/mod/pwr switch : this switch controls the function of the meter during the transmit mode. In the “swr” position, the meter indicates the standing wave ratio (swr) of your antenna. There are no adjustments because the swr circuit in this radio calibrates itself automatically. When the switch i...
27. Gnf led : this led lights red when the gnf is on. 28. R.B. Led : this led lights green when the roger beep is on. 29. Frequency counter : this display indicates the frequency of the selected channel. 30. Pa led : this led lights red when the radio is in the pa mode. 31. Anl led : this led lights...
Frequency chart channel channel frequency channel channel frequency 1 26.965 mhz 21 27.215 mhz 2 26.975 mhz 22 27.225 mhz 3 26.985 mhz 23 27.255 mhz 4 27.005 mhz 24 27.235 mhz 5 27.015 mhz 25 27.245 mhz 6 27.025 mhz 26 27.265 mhz 7 27.035 mhz 27 27.275 mhz 8 27.055 mhz 28 27.285 mhz 9 27.065 mhz 29 ...
Receiving ssb signals there are three types of signals presently used for communications in the citizens band : am, usb, lsb. When the mode switch on your unit is placed in the am position, only standard double-side band, full carrier signals will be detected. An ssb signal may be recognized while i...
Alternate microphones and installation for best results, the user should select a low-impedance dynamic type microphone or a transistorized microphone. Transistorized type microphones have low output impedance characteristics. The microphones must be provided with a four-lead cable. The audio conduc...
5. The wires must now be soldered to the pins as indicated in the above wiring tables. If a vise or clamping tool is available it should be used to hold the pin receptacle body during the soldering operation, so that both hands are free to perform the soldering. If a vise or clamping tool is not ava...
A few rules that should be obeyed 1. You are not allowed to carry on a conversation with another station for more than five minutes at a time without taking a one-minute break, to give others a chance to use the channel. 2. You are not allowed to blast others off the air by over-powering them with i...
• “limited” means that we will repair problems caused by factory defects or normal use at no charge. • before returning a radio to us for warranty service, please call our service department for a repair authorization number (ran). This ran must be written below your return address on the outside of...
