Galaxy DX 45MP Owner's manual

Manual is about: 10 Meter Amateur Mobile Transceiver With StarLite Face Plate

Summary of DX 45MP

  • Page 1

    Dx 45mp 10 meter amateur mobile transceiver with starlite face plate owner’s manual ec h o tim e vo l sq m ic m ic g ain rf g ain o ff ec h o o ff 1 6 0 pw r m o d sw r 0 20 2 1.5 1 3 6 40 s 3 7 5 8 0 +6 0 m a x 10 0 % 3 15 9 12 +4 0 9 +20 db m o d e d tb pw r b a tb o ff c f g h +10kh z am brig h t...

  • Page 2

    - 2 - chapter 1 specifications general model dx 45mp frequency range 28.315 ~ 28.755 mhz emission am/fm frequency control phase-lock-loop (pll) synthesizer frequency stability 0.001% temperature range -30 ° c to +50 ° c antenna impedance 50 ohms antenna connectors standard so-239 type input voltage ...

  • Page 3

    - 4 - ignition noise interference with weak signals, you may experience interference of the signal by background noise. This radio has nb and anl circuits which will help reduce background noise from sources such as your ignition system. However, background electrical noise may come from several sou...

  • Page 4

    - 6 - 5. Rf gain control: this control is used to reduce the gain of the rf amplifier under strong signal conditions. 6. Echo control: this control is used to adjust echo effect. 7. Time control: this control is used to adjust intervals of echo. 8. Channel selector: this control is used to select th...

  • Page 5

    - 8 - rear panel 1. Antenna: this jack accepts a 50-ohm coaxial cable with a pl-259 type plug. 2. Dc power: this jack accepts the 13.8v dc power cable with built-in fuse. The power cord provided with the radio has a black and red wire. The black goes to negative and red goes to positive. 3. Pa sp: t...

  • Page 6

    - 10 - alternate microphones and installation for best results, the user should select a low-impedance dynamic type microphone or a transistorized microphone. Transistorized type microphones have low output impedance characteristics. The microphones must be provided with a four-lead cable. The audio...

  • Page 7

    - 12 - 5. The wires must now be soldered to the pins as indicated in the above wiring tables. If a vise or clamping tool is available it should be used to hold the pin receptacle body during the soldering operation, so that both hands are free to perform the soldering. If a vise or clamping tool is ...

  • Page 8

    Memo warranty this radio is covered by a two year limited parts and labor warranty . “limited” means that we will repair problems caused by factory defects or normal use at no charge. Before returning a radio to us for warranty service, please call our service department for a repair authorization n...

  • Page 9

    Printed in china at0949010o.