Galaxy DX 48T Owner's manual

Manual is about: 10 Meter Amateur Mobile Transceiver With StarLite Face Plate

Summary of DX 48T

  • Page 1

    O ff d im ec h o tim e m ed 20 sw r 0 3 b i g r i g s e r i e s m o d pw r s 1 m a x 5 50 o ff pa pw r m ic g ain rf g ain 1 1. 5 2 3 m ic o ff vo l sq n b/an l tb pw r db +6 0 30 8 0 9 5 7 20 10 40 60 +20 10 0 % 4 0 +4 0 o ff tb table of contents page chapter 1 specifications . . . . . . . . . . . ...

  • Page 2

    - 2 - chapter 1 specifications chapter 2 installation general model dx 48t frequency range 28.315 ~ 28.755 mhz emission am/fm frequency control phase-lock-loop (pll) synthesizer frequency stability 0.001% temperature range -30 °c to +50°c antenna impedance 50 ohms antenna connectors standard so-239 ...

  • Page 3

    Ignition noise interference chapter 3 operation with weak signals, you may experience interference of the signal by background noise. This radio has nb and anl circuits which will help reduce background noise from sources such as your ignition system. However, background electrical noise may come fr...

  • Page 4

    5. Rf gain control: this control is used to reduce the gain of the rf amplifier under strong signal conditions. 17. +10khz-nb/anl/ nb/anl/ off switch: when in the +10khz-nb/anl position, the transmit and receive frequency is shifted up 10khz and the noise blanker (nb) and automatic noise limiter (an...

  • Page 5

    Procedure to receive and transmit rear panel a. Microphone - 8 - m a d e in taiw a n 1 2 ant. Ext.Sp. _ pa.Sp. + power 3 4 the push-to-talk switch on the microphone controls the receiver and transmitter. Press the switch and the transmitter is activated, release switch to receive. When transmitting,...

  • Page 6

    Alternate microphones and installation before beginning the actual wiring, read carefully the circuit and wiring information provided with the microphone you select. Use the minimum heat required in soldering the connections. Keep the exposed wire lengths to a minimum to avoid shorting when the micr...

  • Page 7

    5. The wires must now be soldered to the pins as indicated in the above wiring tables. If a vise or clamping tool is available it should be used to hold the pin receptacle body during the soldering operation, so that both hands are free to perform the soldering. If a vise or clamping tool is not ava...

  • Page 8

    Memo warranty this radio is covered by a two year limited parts and labor warranty. “limited” means that we will repair problems caused by factory defects or normal use at no charge. Before returning a radio to us for warranty service, please call our service department for a repair authorization nu...

  • Page 9

    Printed in taiwan at0949011d.