Galaxy DX-73V Owner's manual

Summary of DX-73V

  • Page 1

    • “limited” means that we will repair problems caused by factory defects or normal use at no charge. • before returning a radio to us for warranty service, please call our service department for a repair authorization number (ran). This ran must be written below your return address on the outside of...

  • Page 2: Specifications

    Table of contents page specification . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2 installation location . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3 mounting the radio . . . . . . . . . . . . . . . . . . . . . . . . . . . 3 ignition noise inter...

  • Page 3: Installation

    Installation location plan the location of the transceiver and microphone bracket before starting the installation. Select a location that is convenient for operation and does not interfere with the driver or passengers in the vehicles. In automobiles, the transceiver is usually mounted below the da...

  • Page 4

    Tunning the antenna for optimum swr since there is such a wide variety of base and mobile antennas, this section will strictly concern itself to the various types of mobile adjustable antennas. Because the antenna length is directly related to the channel frequency, it must be tuned to resonate opti...

  • Page 5: Operation

    Operation control functions front panel 1. Off/on/volume: turn clockwise to apply power to the radio and to set the desired listening level. 2. Squelch control: this control is used to cut off or eliminate receiver background noise in the absence of an incoming signal. For maximum receiver sensitivi...

  • Page 6

    10. Channel selector: this control is used to select a desired transmit and receive channel. 11. Model control: this control allows you to select one of three following operating modes: fm/am/pa. 12. Front panel meter: the front panel meter allows the user to monitor signal strength, rf power out an...

  • Page 7

    Operating a. Microphone the receiver and transmitter are controlled by the press-to-talk switch on the microphone. Press the switch and the transmitter is activated, release switch to receive. When transmitting, hold the microphone two inches from the mouth and speak clearly in a normal “voice”. The...

  • Page 8

    Memo memo - 13 - - 14 -.