Galaxy DX 93T Owner's manual

Manual is about: 10 Meter Amateur Mobile Transceiver With Built-in Frequency Counter & StarLite Face Plate

Summary of DX 93T

  • Page 1

    D x 93t b sw r a m o d t w i n t u r b i n e c d e o ff tb o ff pu sh o ff pu sh n b/an l pu sh ec h o tim e o ff g d im m ic tb h i lo vo l sq pw r h m ed lam p pad 40db o ff m o d lsb fm pa f u sb am rx + 10kh z rx /tx fin e c o arse o ff 5/6 d ig it a n l kh z h ig h sw r alert n b pad + 10 3 0 s...

  • Page 2

    - 2 - chapter 1 specifications general model dx 93t frequency range 28.315 ~ 28.755 mhz emission fm/am/usb/lsb frequency control phase-lock-loop (pll) synthesizer frequency stability 0.001% temperature range -30 ° c to +50 ° c antenna impedance 50 ohms antenna connectors standard so-239 type input v...

  • Page 3

    - 4 - ignition noise interference with weak signals, you may experience interference of the signal by background noise. This radio has nb and anl circuits which will help reduce background noise from sources such as your ignition system. However, background electrical noise may come from several sou...

  • Page 4

    - 6 - 5. Squelch control: this knob is used to eliminate background noise being heard through the receiver, which can be disturbing when no transmissions are being heard through the receiver. To use this feature, turn the knob fully counterclockwise and then turn clockwise slowly until the backgroun...

  • Page 5

    - 8 - rear panel 1. Antenna: this jack accepts a 50 ohm coaxial cable with a pl-259 type plug. 2. Dc power: this jack accepts the 13.8v dc power cable with built-in fuses. The power cord provided with the radio has a black and red wire. The black goes to negative and red goes to positive. 3. Pa sp: ...

  • Page 6

    - 10 - receiving ssb signals there are four types of signals presently used for communications: fm, am, usb and lsb. When the mode switch on your unit is placed in the am position, only standard double-side band and in fm position, only frequency deviation, full carrier signals will be detected. An ...

  • Page 7

    - 12 - alternate microphones and installation for best results, the user should select a low-impedance dynamic type microphone or a transistorized microphone. Transistorized type microphones have low output impedance characteristics. The microphones must be provided with a four-lead cable. The audio...

  • Page 8

    - 14 - 5. The wires must now be soldered to the pins as indicated in the above wiring tables. If a vise or clamping tool is available it should be used to hold the pin receptacle body during the soldering operation, so that both hands are free to perform the soldering. If a vise or clamping tool is ...

  • Page 9

    Memo warranty this radio is covered by a two year limited parts and labor warranty . “limited” means that we will repair problems caused by factory defects or normal use at no charge. Before returning a radio to us for warranty service, please call our service department for a repair authorization n...

  • Page 10

    Printed in taiwan at0949010g.