Galaxy DX 94HP Owner's manual

Manual is about: 10 Meter Amateur Mobile Transceiver With Built-in Frequency Counter & StarLite Face Plate

Summary of DX 94HP

  • Page 1

    Dx 94hp 10 meter amateur mobile transceiver with built-in frequency counter & starlite face plate owner’s manual 1 table of contents page chapter 1 specifications . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2 chapter 2 installation . . . . . . . . . . ...

  • Page 2

    2 chapter 1 specifications general model dx 94hp frequency range 28.315 ~ 28.755 mhz emission am/usb/lsb frequency control phase-lock-loop (pll) synthesizer frequency stability 0.001% temperature range -30 ° c to +50 ° c antenna impedance 50 ohms antenna connectors standard so-239 type input voltage...

  • Page 3

    4 ignition noise interference with weak signals, you may experience interference of the signal by background noise. This radio has nb and anl circuits that will help reduce background noise from sources such as your ignition system. However, background electrical noise may come from several sources ...

  • Page 4

    6 away from the microphone. In the public address (pa) mode, the control functions as the volume control. 6. Rf gain control: adjust this knob for desired level of incoming signal. 7. Dim control: this knob controls the level of brightness for the meter lamp, faceplate, frequency display and channel...

  • Page 5

    8 rear panel 1. Antenna: this jack accepts a 50-ohm coaxial cable with a pl-259 type plug. 2. Dc power: this jack accepts the 13.8v dc power cable with built-in fuses. The power cord provided with the radio has a black and red wire. The black goes to negative and red goes to positive. 3. Pa sp: this...

  • Page 6

    10 receiving ssb signals there are four types of signals presently used for communications: fm, am, usb and lsb. When the mode switch on your unit is placed in the am position, only standard double-side band and in fm position, only frequency deviation, full carrier signals will be detected. An ssb ...

  • Page 7

    12 alternate microphones and installation for best results, the user should select a low-impedance dynamic type microphone or a transistorized microphone. Transistorized type microphones have low output impedance characteristics. The microphones must be provided with a four-lead cable. The audio con...

  • Page 8

    14 5. The wires must now be soldered to the pins as indicated in the above wiring tables. If a vise or clamping tool is available it should be used to hold the pin receptacle body during the soldering operation, so that both hands are free to perform the soldering. If a vise or clamping tool is not ...

  • Page 9

    16 memo 17 memo.

  • Page 10

    18 warranty this radio is covered by a two year limited parts and labor warranty . Z “limited” means that we will repair problems caused by factory defects or normal use at no charge. This warranty does not cover any modifications made to the radio and any modification may void the warranty complete...

  • Page 11

    20 printed in taiwan atdx98010c.