Galaxy DX 95T Owner's manual

Manual is about: 10 Meter Amateur Mobile Transceiver With Built-in Frequency Counter & StarLite Face Plate

Summary of DX 95T

  • Page 1

    Dx 95t u s f 10 meter amateur mobile transceiver with built-in frequency counter & starlite face plate owner’s manual pu sh f. D isp o ff +6 0 8 0 60 1 95t 8 0 d x 4 0 1 20 0 sw r pw r m o d 3 1.5 2 4 0 20 60 10 m a x 10 0 % 100 sw r o ff vo l sq o ff pw r m o d rb pu sh tb o f g n f m ic tb ec h o ...

  • Page 2

    Chapter 1 specifications chapter 2 installation general model 3 dx 95t frequency range 28.315 ~ 28.755 mhz emission fm/am/usb/lsb frequency control phase-lock-loop (pll) synthesizer frequency stability 0.001% temperature range -30 ° c to +50 ° c antenna impedance 50 ohms antenna connectors standard ...

  • Page 3

    Ignition noise interference chapter 3 operation with weak signals, you may experience interference of the signal by background noise. This radio has nb and anl circuits which will help reduce background noise from sources such as your ignition system. However, background electrical noise may come fr...

  • Page 4

    5. Squelch control: this knob is used to eliminate background noise being heard through the receiver, which can be disturbing when no transmissions are being heard through the receiver. To use this feature, turn the knob fully counterclockwise and then turn clockwise slowly until the background nois...

  • Page 5

    Rear panel 23. Nb/anl led: this led lights green when the nb/anl circuit is on. 24. Channel display: the channel display indicates the current selected channel. 25. Pad led: this led lights green when the 40db attenuator circuit is on. Notes high swr alert: all three leds (nb/anl, gnf & pad) light r...

  • Page 6

    Procedure to receive and transmit receiving ssb signals a. Microphone there are four types of signals presently used for communications: fm, am, usb and lsb. When the mode switch on your unit is placed in the am position, only standard double-side band and in fm position, only frequency deviation, f...

  • Page 7

    Alternate microphones and installation thus when a voice is used in place of a whistle or tone, in the proper listening mode the voice will be received correctly whereas in the incorrect mode, the voice will be translated backwards and cannot be made intelligible by the coarse/fine control. When lis...

  • Page 8

    Before beginning the actual wiring, read carefully the circuit and wiring information provided with the microphone you select. Use the minimum heat required in soldering the connections. Keep the exposed wire lengths to a minimum to avoid shorting when the microphone plug is reassembled. 5. The wire...

  • Page 9

    Memo 9. The two cable clamp retainer screws should now be tightened to secure the housing to the microphone cord. If the cutting directions have been carefully followed, the cable clamp should secure to the insulation jacket of the microphone cable. 10. Upon completion of the microphone plug wiring,...

  • Page 10

    Warranty this radio is covered by a two year limited parts and labor warranty . “limited” means that we will repair problems caused by factory defects or normal use at no charge. Before returning a radio to us for warranty service, please call our service department for a repair authorization number...