Galaxy G9000S Installation Instructions Manual

Summary of G9000S

  • Page 1

    Important! This step-by-step guide should be given to the customer after installation and demonstration. Instantaneous electric shower installation instructions technical hotline telephone: 0844 372 7766 fax: 0844 372 7767 email: technical-services@applied-energy.Com 9.00 am - 5.00 pm monday to frid...

  • Page 2

    Pack contents shower unit showerhead flexible hose slider rail tube slider rail brackets slider rail showerhead holder soap dish screw pack important 1. Shower installation must be carried out by a suitably qualified person and conform with iee regulations and national water council bylaws. 2. This ...

  • Page 3

    Remove the two screws securing the shower unit cover and remove the cover complete with the control knobs. Place the shower unit on the wall and mark the location of the fixing screws through the back plate. Carefully drill the holes as marked using a sharpe 5.5mm masonry drill. Avoid connecting the...

  • Page 4

    7 section fitting the cover into position 1. Turn the flow control knob spindle anti- clockwise until the valve is fully open, before switching on the unit (see fig 1). This will ensure a fast fill up of the unit when the shower is first switched ‘on’. Important! The shower must be full of water bef...

  • Page 5

    Maintenance: clean regularly with a non-abrasive liquid bathroom cleaner. 9 section commissioning the shower 1. Make sure that the electrical supply has been isolated at the double pole isolating switch. 2. Turn the top power selector knob to the ‘cold’ setting (solid blue symbol). 3. Turn the botto...

  • Page 6

    11 section operating features power neon indicator the ‘power’ neon indicator will be illuminated when the shower unit is switched on and water is flowing on the heat settings. The light will not come on when the shower unit is on the cold setting. Overheat increase flow overheat increase flow neon ...