Galaxy NNJ-3130JT Instruction Manual - page 3
04
03
Detailed Assembly Method
/ Assembly Method for Juicing Bowl Set
/ Assembly Method for Juicing Bowl Set and Base
Before the usage,
please check!
Use the set after sufficiently washing the juicing bowl set.
Check that squeeze silicon and silicon ring are correctly plugged.
Fully fit the squeeze silicon to the bottom of
the container in the direction of arrow as
shown in the photo.
Fit the rotation wiper to the strainer and
align the point in the strainer and
rotation wiper to assemble.
Caution
If the squeezed silicon and the silicon ring
is not completely fitted in, the juice amount
may be little or the juice may seep out.
Caution
When assembling the juicing bowl set to
the base, securely turn it until a clicking
sound is made. If it is not tightened
properly, it does not operate.
Turn the screw in the center of strainer
and gently press it down.
Align each of points in the juicing bowl
set and drum lid, and turn it in clockwise
direction to align at point to close it.
Caution
If the screw is not fully tightened, bowl and
drum cannot be tightened.
After raising the juicing bowl set on the
base, point in the drum lid with point
in the base and turn it in the direction of
(close) direction
Match the pulp cup and juice up at the
outlet as shown in the photo.
Silicon Ring/Silicon Brush
After separating it for washing, it must be put
back in the direction shown in the photo for use.
Put the wide surface to the top to use.
Aim the tail side to the bottom to use.
Depending on the product model, the actual product's color may be different.