Galileo international technical support documentation tcp/ip print server changing tcp/ip or host access configuration.
Copyright copyright © 2001 galileo international. All rights reserved. Information in this document is subject to change without notice. The information described in this document is furnished to galileo international subscribers, or their representatives, and is provided as is under a license agree...
Tcp/ip print server – changing tcp/ip or host access configuration (10/29/01 mlr) 3 introduction tcp/ip print servers, not to be confused with network print servers such as hp jetdirect, are used to receive and distribute messages to the various apollo® printing devices. This includes ticket printer...
Tcp/ip print server – changing tcp/ip or host access configuration (10/29/01 mlr) 4 accessing the tcp/ip print server configuration utility from the print server monitor screen, press the f3 key to exit to a dos prompt. From a dos prompt: type “1” and press enter. If the configuration screen did not...
Tcp/ip print server – changing tcp/ip or host access configuration (10/29/01 mlr) 5 save and back-up print server configuration after making any changes to a tcp/ip print server, save the changes and back them up or any change may be lost. From the tcp/ip print server configuration utility, arrow le...
Tcp/ip print server – changing tcp/ip or host access configuration (10/29/01 mlr) 6 changing tcp/ip network information from the tcp/ip print server configuration utility, arrow left to the configure drop down menu. File configure help ip stack network parameters printer ports manual override arrow ...
Tcp/ip print server – changing tcp/ip or host access configuration (10/29/01 mlr) 7 changing configuration server addresses and client identifier from the tcp/ip print server configuration utility, arrow left to the configure drop down menu. File configure help ip stack network parameters printer po...
Tcp/ip print server – changing tcp/ip or host access configuration (10/29/01 mlr) 8 assigning gtids to the correct artic card port the gtid or global terminal id must be assigned to the correct port to where the print device is connected. Artic cards may have either 4 or 8 ports where port “0”, or t...
Tcp/ip print server – changing tcp/ip or host access configuration (10/29/01 mlr) 9 if necessary, change the gtid on an assigned port. Do not change the baud, parity, data or stop. If the settings do not match those above, please contact your galileo or apollo account representative before making an...
