Gallet GALCCH 120 Instruction Manual - page 26

ENG - 26

•  Lay the electric blanket flat on the bed. The end without controls is the foot end. Put only 

spread sheets on the blanket, so as to help the conduct of the heat and check whether the 

electric blanket is not creased. Lay the quilt flat on the sheet to use the electric blanket safely.

•  General temperature adjustment: Plug power cord into an AC 230 V - 50 Hz wall outlet (do 

not connect this appliance with Daily Clock timer). 

•  To operate, you can choose different temperatures 1-9 and 1-9 hours timer or the maximum 

choice 12 hours.

•  Main switch turn to position 1

•  LED lights display. Press TIMER to set the time on and pressing the „TEMP“ to desired 

temperature.

•  When LED shows” H” , it means 12 hours timer.              

•  For turning off push main switch to “0 position” (the LED switches off).

•  When the electric blanket is on, the control must not be covered. Make sure not to put the 

control under the quilt or the pillow, or other objects, let alone close to other heating sources - 

the control could be overheated and damaged.

•  If you sleep on the blanket, can not be turned on all night.

NOTE:

 You may notice and odour when using the blanket for the first time, due to the insulation 

material. This is harmless and will subside quickly. The highest 9 can be used only for preheat 

1h and not for continuous operation, We recommended that preset 4 for whole night use 

Original setting for the control is 1 hour timer and 0 heat setting.

CLEAN AND MAINTENANCE

DAILy CHECKS AND SAfEGUARD

To guarantee safe use of the electric blanket, pay attention to the following items:

1)  Pay attention to power cords, plug, soft cords and control. If you are not sure whether it 

is safe or not to use the blanket, do not use the product and send it to service center for 

maintenance or check.

2)  During using, check regularly that the electric blanket is leveled, fixed firmly and not fold or 

rolled. Make amends to situations that influence normal use in time.

3)  Often check whether there is wear and tear mark on the appliance (including the soft cord). 

If so or if this appliance was used incorrectly, return the product to the service center.

4)  The heating wire in the electric blanket should be spaced evenly, wired smoothly, should not 

cross or fold. Do not use the device otherwise, and send it to the service center for check. 

Check method: lay the electric blanket flat on the bed; touch the heating wires with hand.

5)  When the electric blanket is on the bed, do not allow children to jump on the bed. If this 

already happened check carefully that no part of the electric blanket is damaged.

6)  When an accident or damage takes place (smoke, fire, abnormal sound, abnormal smell, 

etc.), cut off the electric blanket power first (pull out the plug), then do other treatment, such 

as check at the service center.

7)  Do not use a blanket young children if the device is not set by a parent or guardian or if the 

child was not adequately instructed how to safely operate the control of device.

fOR wASHING THE HEATING BLANKET

Before washing the heating blankets, the users must read the instructions.

You can wash the blanket, but do not dry-clean this blanket.

Before washing the heating blankets, make sure that the blankets are in a good working 

condition and are not damaged.

1)  Take the blankets from the bed and disconnect the detachable connector to make sure that 

the controller and power cord are not connected to the blankets.